User manual HOTPOINT PH 741 RQO GH U/HA

[. . . ] 11 Operating Instructions HOB Contents PL Polski, 1 GB GB English, 12 Installation, 13-16 Positioning Electrical connection Gas connection Burner and nozzle specifications Data plate Description of the appliance, 17 Overall view Start-up and use, 18-19 Practical advice on using the burners Practical advice on using the the Ceramic Glass Module Precautions and tips, 20 PH 741 RQO GH U/HA General safety Disposal Maintenance and care, 21 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 22 Installation  Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance.  Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Replace the nozzle with models suited to the new type of gas (see table 1). Replace all the components by repeating the steps in reverse order. GB • Adjusting the burners’ primary air : Does not require adjusting. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. Some appliances have a safety device (thermocouple) fitted. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance.  If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible.  Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Stickers are available from any of our Service Centres.  Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). 6 MJ/m³  The hob can only be installed above built-in ovens with a cooling ventilation system. - 2002/96/EC 16 Description of the appliance Overall view CERAMIC GLASS MODULE GAS BURNERS GB Support Grid for COOKWARE INDICATOR LIGHT FOR CERAMIC GLASS MODULE Control Knobs for GAS BURNERS and ELECTRIC HOTPLATES SAFETY DEVICES Ignition for GAS BURNERS • The INDICATOR LIGHT FOR CERAMIC GLASS MODULE switches on whenever the selector knob is moved from the ‘off’ position. Use the diameter of the cookware to choose the most appropriate burner to cook with. • Control Knobs for GAS BURNERS and ELECTRIC PLATES adjust the power or the size of the flame. GAS BURNER ignition enables a specific burner to be lit automatically. • SAFETY DEVICE stops the gas flow if the flame is accidentally extinguished. The selected burner can be regulated using the corresponding knob, as follows: • Off Maximum Minimum To switch off the burner, turn the knob in a clockwise direction until it stops (when reaches the “•” position). Ceramic Glass Module This cooktop is fitted with dual-ring radiant heating elements located beneath the glass. It is possible to turn on only the circular part of the elemement (identified by the letter "A") or the cooking surface can be enlarged by turning on both "A" and "B". To turn only the circular "A" element, simply turn the knob in the clockwise direction to any one of the 12 available settings. [. . . ] Clean the cooking surface when it is still warm with a suitable cleaning product (such as the one in the Solutions product line available from any AfterSales Service Centre) and paper towels. Aluminum foil, plastic Gas tap maintenance Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced.  This procedure must be performed by a qualified technician authorised by the manufacturer. [. . . ]