User manual HOTPOINT PK 640 R L GH AG

[. . . ] Operating Instructions HOB Contents Installation, 2-6 GB English, 1 GB ES Español, 14 PT Português, 29 Positioning Electrical connection Gas connection Data plate Burner and nozzle specifications Description of the appliance, 7 Overall view Start-up and use, 8-10 Practical advice on using the burners Practical advice on using the the Ceramic Glass Module Precautions and tips, 11 PK 741 RQO GH AG PK 750 RL GH AG PK 640 RL GH AG PK 760 RF GH AG General safety Disposal Maintenance and care, 12 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 13 1 Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] To shift between levels, simply turn the knob towards the desired power level. A click signals the passage from one power level to the other. The selected power level is indicated by the corresponding symbol ) and, on (symbols hobs equipped with a display, by the LEDs that turn on (5 = max. The system guarantees accurate flame adjustment and uniform cooking results by facilitating selection of the desired power level. The "double-flame" burner This gas burner consists of two concentric flame rings that can operate jointly or independently (in case of dual-control only). As the burner is fitted with a safety device, the knob should be pressed down for approximately 2-3 seconds until the device keeping the flame automatically alight heats up. Dual control: Each ring comprising the burner has its own control knob: controls the The knob marked with the symbol outer ring. Controls the The knob marked with the symbol inner ring. To activate any one of the two rings, press the corresponding knob and turn it anti-clockwise to the . Maximum power setting In order to use the double-flame burner to its full potential, avoid simultaneously setting the inner ring to minimum power and the outer ring to maximum power. Single control: The rings comprising the burner are activated through a single control knob. To simultaneously turn on both rings, position the (max. ) then press knob on the symbol and turn the knob anti-clockwise. To turn on the inner ring only, position the knob on (max. ) then press and turn the symbol the knob clockwise. (to switch modes, it is necessary to switch off the burner). To switch off the burner, press and turn the knob clockwise until it stops (when it reaches the "•" position). Ceramic Glass Module* This cooktop is fitted with dual-ring radiant heating elements located beneath the glass. It is possible to turn on only the circular part of the elemement (identified by the letter "A") or the cooking surface * Only available on certain models. GB 8 can be enlarged by turning on both "A" and "B". To turn only the circular "A" element, simply turn the knob in the clockwise direction to any one of the 12 available settings. To add the "B" section, turn the knob to setting 12 and then click it into the setting. [. . . ] Clean the cooking surface when it is still warm with a suitable cleaning product (such as the one in the Solutions product line available from any AfterSales Service Centre) and paper towels. Aluminum foil, plastic Gas tap maintenance Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. [. . . ]