User manual HOTPOINT RDPD 107617 JKD EU

[. . . ] This symbol reminds you to read this instruction manual. GB GB English, 1 PL Polski, 13 DE Deutsch, 25 Contents Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 4 Cutting off the water or electricity supply Cleaning the washer-dryer Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose RDPD 107617 J Precautions and tips, 5 General safety Disposal Opening the porthole door manually Description of the washer-dryer, 6-7 Control panel Display How to run a wash cycle or a drying cycle, 8 Wash cycles and functions, 9 Table of wash cycles Wash functions Detergents and laundry, 10 Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system Troubleshooting, 11 Service, 12 1 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washer-dryer is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/ herself with its operation and features. [. . . ] Press buttons X and Y to choose the desired level of luminosity then confirm by pressing button Z. During the wash cycle or when the DELAY TIMER function has been enabled, if the user does not interact with the display for 1 minute the “SCREEN SAVER” activates. To return to the previous window, simply press any button. 7 How to run a wash cycle or a drying cycle GB 1. Press the On/Off button ; the text HOTPOINT will appear on the display and the START/ PAUSE indicator light will flash slowly in a green colour. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes on the following page. Open the detergent dispenser drawer and pour the detergent into the relevant compartments as described in “Detergents and laundry”. Use the WASH CYCLE SELECTOR knob to select the desired wash cycle; the name of the wash cycle will appear on the display. A temperature and spin speed is set for each wash cycle; these may be adjusted. The duration of the cycle will appear on the display. Use the relevant buttons: Modifying the temperature and/or spin speed. The machine automatically selects the maximum temperature and spin speed set for the selected wash cycle; these values cannot therefore be increased. The temperature can be decreased by pressing the button, until the cold wash (the display will visualise the “--” symbol) setting is reached. The spin speed may be progressively reduced by pressing the button, until it is completely excluded (the display will visualise the “--” symbol). If these buttons are pressed again, the maximum values are restored. Exception: if the 5 programme is selected, the temperature can be increased up to a value of 40°C. Exception: if the 7 programme is selected, the temperature can be increased up to a value of 90°C. Exception: if the 9 programme is selected, the temperature can be increased up to a value of 60°C. To set a delayed start for the selected programme, press the corresponding button repeatedly until the required delay period has been reached. To remove the delayed start function press the button until the text “-- h” appears on the display. The desired drying cycle type may be set by pressing the DRYING button once or several times. Two options are available: A - Based on the how damp the clothes are once they have been dried: Iron: suitable for clothes which will need ironing afterwards. [. . . ] €¢ The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). €¢ The free end of the hose is under water (see “Installation”). €¢ The wall drainage system is not fitted with a breather pipe. If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the Assistance Service. [. . . ]