User manual HOTPOINT SD 1711

[. . . ] If the floor is not perfectly horizontal, adjust the refrigerator by tightening or loosening the front feet. Electrical connections After the appliance has been transported, carefully place it vertically and wait at least 3 hours before connecting it to the electricity mains. Before inserting the plug into the electrical socket ensure the following: • The appliance is earthed and the plug is compliant with the law. • The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. [. . . ] • Remember that cooked foods do not last longer than raw foods. Do not store liquids in open containers. They will increase humidity in the refrigerator and cause condensation to form. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Height can be adjusted without complete removal of the shelf. Setting the temperature The temperature inside the refrigerator compartment automatically adjusts itself according to the position of the thermostat knob. 1 = warmest MAX = coldest We recommend , however , a medium position. The cooling section of the refrigerator is located inside the back wall of the refrigerator compartment for increased space and improved aesthetics. During operation, the back wall will be covered in frost or water droplets depending on whether the compressor is operating or paused. Do not worry, the refrigerator is functioning normally. If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature, the appliance can operate continuously, resulting in excessive frost formation and excessive energy consumption: compensate for this by shifting the knob towards lower values (defrosting will occur automatically). In static appliances, the air circulates in a natural way: the colder air tends to move downwards as it is heavier. The food should be stored as follows: )RRG Fresh fish and meat Fresh cheese Cooked food Salami, bread loaf, chocolate Fruit and vegetables Eggs $UUDQJHPHQW LQVLGH WKH UHIULJHUDWRU Above the fruit and vegetable bins Above the fruit and vegetable bins On any shelf On any shelf In the fruit and vegetable bins On the shelf provided 1 2 Food hygiene 1. Once you have bought your food, remove all external packaging made of paper/cardboard or other wrappers, which could introduce bacteria or dirt inside your refrigerator. Protect the food, (especially easily perishable items and those that have a strong smell), in order to avoid contact between them, thereby removing both the possibility of germ/bacteria contamination as well as the diffusion of strong odours inside the fridge. Store all food in such a way as to ensure air can circulate freely between different items. Keep the inside of your fridge clean, taking care not to use oxidiser or abrasive products. Remove all food past its expiry date from the refrigerator. For the correct preservation of food, all easily perishable items (soft cheeses, raw fish, meat, etc. ) should be stored in the coldest zone of the fridge compartment, i. Just above the salad crisper where the temperature indicator is situated. Butter and margarine On the shelf provided Bottles, drinks, milk On the shelf provided 16 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on OFF (appliance off) to eliminate all electrical contact. [. . . ] • The appliance has not been installed on a level surface (see Installation). • The appliance has been installed between cabinets that vibrate and make noise. • The internal refrigerant makes a slight noise even when the compressor is off. The back wall of the refrigerator unit is covered in frost or droplets of water There is water at the bottom of the refrigerator. [. . . ]