User manual HOTPOINT SI DC30 BA0

[. . . ] € Supervise children to prevent them from playing with the appliance. € Never leave the appliance unattended when the plug is connected into the electrical socket. € After each use of the appliance, when filling and emptying the water reservoir, as well as when cleaning the appliance, set the steam regulator to Off. Then place the appliance in a stable position, using the stand, and disconnect the plug from the electrical socket. [. . . ] We recommend to check the garment label in order to identify the fabric type. In case of doubts, it is recommended not to use the spray function and iron a hidden corner in order to determine the most appropriate temperature and avoid damaging the fabric. In case of very delicate fabrics, such as silk, wool, and synthetic materials, iron the garment inside out to prevent shiny marks. Start ironing the garments that require a lower temperature, such as synthetic fabrics. Fabrics with this symbol on the label must not be ironed. FABRIC TYPE TEMPERATURE INDICATION MIN STEAM INDICATION steam button several times to (re)activate the pump, after filling the water reservoir again. Select the recommended ironing temperature with the temperature buttons +/- (4a) (see step B1 and chapter “Using the iron”, section “Selecting the temperature and adjusting the steam”). Check that the water level in the reservoir is higher than ¼. Select the appropriate steam with the steam regulator (3) and the recommended ironing temperature with the temperature buttons +/(4a) (see step B1 and chapter “Using the iron”, section “Selecting the temperature and adjusting the steam”). Ironing with shot of steam (E1) The shot of steam function allows you to eliminate persistent wrinkles. You can use this function both in no-steam and steam ironing mode. Check that the water level in the reservoir is higher than ¼. With the iron in horizontal position, press the spray button (2) to dampen the garment. If you leave the iron unattended, the display flashes a green light and an acoustic signal is emitted to inform that the automatic stand-by function is active. Simply move the iron or press the temperature buttons +/- (4a) to switch it back on. Wait until the display becomes red before starting ironing again. automatic switch-off function (H2) The automatic switch-off function guarantees total safety. This function automatically switches off the iron when it is not used for a few minutes. In particular: • • the iron switches off automatically after 30 seconds when left unattended in the ironing position or sideways; the iron switches off automatically after 10 minutes when left unattended in the rest position (vertical). vertical steam function (G) The vertical steam function is useful to eliminate wrinkles from hanging garments , curtains , etc. You can use this function by simply placing the iron in vertical position. All functions of the appliance will remain unchanged also in this position (refer to chapter “Use” according to the model). [. . . ] Replace the iron in vertical position, using the stand, and wait until the temperature indicator light tuns off or the LCD becomes red before starting to iron. The plate temperature may be too low due to the excessively frequent activation of the shot of steam button. Slightly increase the interval between steam shots. There may be residues in the vaporisation chamber. [. . . ]