User manual HOTPOINT SI DC30 BA1

[. . . ] En GENERAL SAFETY INSTRUCTIONS • Do not operate the iron in case of damaged plug, power cord or appliance, or in the presence of visible damage or water leaks from the appliance. In such a case the appliance must be inspected by the Hotpoint authorized technical staff in order to avoid dangerous situations. € If the appliance was dropped, do not operate it. € The appliance is not intended to be used by individuals (children included up to 8 years of age) with impaired physical, sensory or mental capabilities, inexpert individuals or individuals who are not familiar with the product, unless they are supervised by a person responsible for their safety, or by individuals who have not received preliminary instructions on the use of the appliance. [. . . ] If the shot of steam function has not been used for some time, it may be necessary to press the button repeatedly to activate the pump. Select the recommended ironing temperature with the temperature control (4b) (see step B2 and chapter “Using the iron”, section “Selecting the temperature and adjusting the steam”). Check that the water level in the reservoir is higher than ¼. Select the appropriate steam with the steam regulator (3) and the recommended ironing temperature with the temperature selector (4b) (see step B2 and chapter “Using the iron”, 5. Select the steam level with the steam regulator (3) or move it to Off to iron without steam. When steam ironing, make sure that the water level in the reservoir is at least ¼. The iron starts producing steam as soon as it reaches the set temperature. If the water in the reservoir is finished, it may be necessary to press the shot of 25 en it section “Selecting the temperature and adjusting the steam”). Ironing with shot of steam (E2) The shot of steam function allows you to eliminate persistent wrinkles. You can use this function both in no-steam and steam ironing mode. Check that the water level in the reservoir is higher than ¼. Select the recommended ironing temperature with the temperature control (4b) (see step B2 and chapter “Using the iron”, section “Selecting the temperature and adjusting the steam”). Press the shot of steam button (1) to obtain an extra steam flow when ironing. If the shot of steam function has not been used for some time, it may be necessary to press the button repeatedly to activate the pump. automatic Stand-by function (H1) LCD The automatic switch-off function guarantees total safety. This function automatically switches off the iron when it is not used for a few minutes. In particular: • • the iron switches off automatically after 30 seconds when left unattended in the ironing position or sideways; the iron switches off automatically after 10 minutes when left unattended in the rest position (vertical). FEATURES Spray function (F) The spray function is used to dampen the garment in order to remove persistent wrinkles easily. You can use the spray function both in no-steam and steam ironing mode at any temperature. Check that the water level in the reservoir is higher than ¼. Never store the iron in horizontal position. Always use the stand at the back of the iron. [. . . ] Make the cleaning operations (see chapter “Cleaning and maintenance”, section “Auto-Clean Function” according to the model). You are using perfume, vinegar, starch, vinegar, starch, scaleremoving agents, ironing products or other chemical substances. Remember that these substances may damage the product. You can use starch directly on the inside out of the fabrics and in any case never in the water reservoir. [. . . ]