User manual HOTPOINT TCD 87 B 6K

[. . . ] This symbol reminds you to read this booklet. 1 Installation GB Where to put your dryer Place your dryer at a distance from gas ranges, stoves, heaters, or cook tops because flames can damage the appliance. Minimum gap 10mm If you are going to install the appliance under a work counter, be sure to leave a Minimum gaps 10mm space between 15mm the top and any other objects on or above the machine and a 15mm space between the sides and lateral furnishings or walls. This is to ensure proper air circulation. [. . . ] Open the door, take the laundry out, clean the filter and replace it. My Cycle button: First time you press this button the display will show PRESS AND HOLD TO STORE After selecting your favorite programme and options you can save these settings by pressing and holding in the My Cycle button for at least 5 seconds, the top line will show a flashing followed by the selected programme. The buzzer will then beep and the second line of the display shows MEMORY The next time you need this programme press the button, then the Start/Pause button and this programme will run. If you wish, you can change your stored favorite, by selecting a new programme and/or options and press and hold in the button (as above). 10 Start and Programmes Programmes Table !If the Display is not lit; Press the ON/OFF button Programme Options available and then select programme. dryness Levels available (default highlighted ✓ ) Hanger Dry Plus Cupboard Dry GB Sound or *Crease Care Hanger Dry Delay Timer Sensor Dry Damp Dry Extra Care Heat Level Timed Dry Standard Cotton 1 Shirts Cotton Bed & Bath 2 Anti Allergy Synthetics 3 Shirts Synthetic ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✗ ✗ ✓ ✓ ✗ ✓ ✗ ✗ ✗ ✗ ✗ ✓ ✗ ✓ - High - High - Medium - Low ✗ ✗ - High - Medium ✗ - Medium - Medium - Low ✗ ✓ ✓ ✗ ✗ ✗ ✗ ● ✓ ✗ ✓ ✓ ✓ ✓ ✓ ✗ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✗ ✓ ✓ ✓ ✗ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✗ ✓ ✗ ✗ ✗ ✓ ✗ An Automatic programme ✗ ✗ ✓ ✗ *YOU CANNOT SELECT BOTH CREASE CARE AND SOUND OPTIONS Standard Cotton ● ● ● This is a programme for cotton items. The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer (see Laundry). The Standard Cotton programme to EU Regulation 392/2012 is Programme 1 selection with High Heat and Dryness Level Cupboard Dry. Shirts Cotton This is a programme for shirts made from cotton. — It can be used for load sizes up to 3kg (approximately 10 shirts). It can be used for load sizes up to 3kg (approximately 4 pairs). — Do not mix dark and light coloured items. — It can also be used on other garments made from the same material, such as jackets. — The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer. — Loads dried using the Extra Dry setting are usually ready to wear, the edges or seams may be slightly damp. If this is the case, try turning the jeans inside out and running the programme again for a short period. We do not recommend that you use this programme if your jeans have elastic waist bands, studs or embroidery. Take care with this programme DO NOT dry any items that are damaged which could result in the filling blocking the filter and air vent resulting in a fire hazard. — Must only be used on single size duvets: NOT suitable for double or king size items. — Loads dried using this programme are usually ready to use, but may be slightly damp in places. If this is the case, try opening them out and shaking them and running the programme again for a short period. [. . . ] — The lights on the dryer control panel are off although the dryer is switched on. ● 16 Service Before calling the Service Centre: ● Spare Parts This dryer is a complex machine. Repairing it yourself or having a non-authorised person try to repair it could cause harm to one or more persons, could damage the machine and could invalidate the spare parts warranty. Call an authorised technician if you experience problems while using the machine. [. . . ]