User manual HOTPOINT VS S15 AAW

[. . . ] En GENERAL SAFETY INSTRUCTIONS • This appliance must not be used by children. € Keep the appliance and its cord out of reach of children. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. € The equipment was designed for household and similar uses such as in: -  taff kitchen areas in shops, offices and other work environments; s - farm houses; -  otels, motels and other residential environments by the guests; h - bed&breakfast-type environments. [. . . ] Your device was designed to clean hard floors which resist to high temperatures. Do not use on wooden unsealed floors and on floors made on nonenamelled ceramic floors. The action of both heat and steam could remove the brightness on floors previously treated with wax. We always recommend to test your device on an isolated area of the floor before you use it on the whole surface. Please check the usage and maintenance instructions given by the producer of your floor. € • • • • • • • • • • • • • • • • • • BEFORE USE The product is inspected with different tests before it is produced and sold in order to guarantee a higher level of quality. This is the reason why it’s normal to find some water drops in the tank when you open the box. please remove all stickers , protective plastic or carton boxes from the device itself. Please make sure all stickers get removed with a soft wet cloth. mounting (A) Please mount the device as follows: 1. Insert the handling pipe (8) in the pipe housing handle (7) until it stops. Insert the fixing screw and firmly fasten it. Insert the dust container (2) in its housing, by positioning first in the upper part and then in the lower part until you hear the click of “closing complete”. [Tap water : de-mineralized water] Ratio 1:0 2:1 1:1 1:2 0:1 USE OF THE VACUUM MODE (B) Do not use the device without filters (14) or without the dust container (2), ad it could get damaged. Unwind the power cable (12) and insert the plug of the device in a wall socket (220-240V). Before you connect the device to the electrical plug, please unwind all the power cable to avoid its heating up and avoid damaging it. Turn the power electronic regulator clockwise (3) in order start the device in vacuum mode. Position the power electronic regulator so that it is in line with the symbol. In order to turn off the device, please turn the power electronic regulator anticlockwise by positioning it in line with the Off symbol. Wind the cable around the top cable-winder support (10) and the bottom cable-winder support (11). Pull and turn the top cable-winder support to completely unwind the cable. Before you connect the plug to the wall socket, please completely unwind the power cable in order to avoid its overheating or to avoid damaging it. [. . . ] Should this be necessary, please replace them. Please make sure that the brush and the suction tubing are not obstructed. Please clean the dust container and its filters. One or more tools were not mounted correctly. [. . . ]