User manual HOTPOINT WML 621 EU.M

[. . . ] Instructions for use WASHING MACHINE Contents GB English, 1 GB RO Română, 13 SR Cрпски, 25 Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data BG Български, 37 Care and maintenance, 4 Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 5 WML 621 General safety Disposal Description of the washing machine and starting a wash cycle, 6-7 Control panel Indicator lights Starting a wash cycle Wash cycles, 8 Table of wash cycles Personalisation, 9 Setting the temperature Setting the spin speed Functions Detergents and laundry, 10 Detergent dispenser drawer Preparing the laundry Garments requiring special care Load balancing system Troubleshooting, 11 Service, 12 1 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again. Set the WASH CYCLE knob to the desired programme. Set the spin speed (see “Personalisation”). Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed manner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle. At the end of the wash cycle the indicator light will switch on. The DOOR LOCKED indicator light will switch off, indicating that the door may be opened (wait approximately 3 minutes). Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washing machine off by pressing the ON/OFF button. Speed (rpm) Total water lt Wash cycles Detergents Prewash Bleach Wash Description of the wash cycle Fabric softener Cycle duration GB 1 Anti Stain 2 Whites 3 Cotton: lightly soiled resistant and delicate colours. 9 Delicates Fast Wash 60’: to refresh normal soiled garments quickly (not 10 suitable for wool, silk and clothes which require washing by hand). 90°) 60° 40° 60° 40° 60° 40° 40° 30° 60° 20° 1200 1200 1200 1200 1200 1000 1000 1200 1000 800 0 1200 1200       -                 -        -                  - 4 4 6 6 6 3 3 4 3 1, 5 1 3, 5 6 6 3 3 6 6 6 - - 76 33 30 36 - 180’ 180’ 115’ 185’ 120’ 110’ 185’ 145’ 80’ 75’ 60’ 180’ 100’ 75’ 30’ 49’ 10’ 3’ 53 1, 02 49, 8 195’ 53 0, 86 44 0, 78 - 53 0, 68 - 12 Eco Cottons 13 Eco Synthetics 14 Eco Fast 30’ Rinse Spin and Pump out Pump out only * Cold Water 1200 Cold Water 1000 Cold Water 800 1200 1200 70 0, 05 and exclude the spin cycle, the machine will drain only. * If you select programme The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. 1) Test wash cycle in compliance with regulation 1061/2010: set wash cycle 4 with a temperature of 60°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 60°C . The actual washing temperature may differ from the indicated value. 2) Test wash cycle in compliance with regulation 1061/2010: set wash cycle 4 with a temperature of 40°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 40°C . The actual washing temperature may differ from the indicated value. For all Test Institutes: 2) Long wash cycle for cottons: set wash cycle 4 with a temperature of 40°C. [. . . ] € The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). € The free end of the hose is under water (see “Installation”). € The wall drainage system is not fitted with a breather pipe. If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the Assistance Service. [. . . ]