User manual HOTPOINT XP 73 G /HA

[. . . ] 12 Operating Instructions HOB GB IT Italiano, 1 GB English, 13 FR Français, 25 Contents Installation, 14-19 Positioning Electrical connection Gas connection Data plate Burner and nozzle specifications DE Deutsch, 38 NL ES Nederlands, 50 Español, 62 Description of the appliance, 20 Overall view Start-up and use, 21 Practical advice on using the burners Precautions and tips, 22 XB PP 73 G/HA B PP 73 G /HA XP 73 G/HA General safety Disposal Maintenance and care, 23 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 24 13 Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuitbreaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • The appliance is earthed and the plug is compliant with the law. € The socket can withstand the maximum power of the appliance, which is indicated on the data plate. € The voltage is in the range between the values indicated on the data plate. € The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. The cable must not be bent or compressed. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. 17 GB label with the one showing the new type of gas; the sticker is available from our Service Centres. Adjusting the low flame • Put the tap to the low flame position; • Remove the tap knob and turn the adjusting screw, situated inside of the tap stem (Fig. 11), using a screwdriver (loosening the screw increases the height of the flame, tightening decreases it). Note: the adjusting screw must be fully screwed down for liquid gas. € Having obtained the low flame setting required and with the burner lit, abruptly change the position of the knob several times from minimum to maximum and vice versa and check that the flame does not go out. The hob can only be installed above built-in ovens with a cooling ventilation system. D C A B B XB PP 73 G /HA B PP 73 G /HA XP 73 G /HA 19 Description of the appliance Overall view GAS BURNERS Support Grid for COOKWARE GB Control Knobs for GAS BURNERS SAFETY DEVICES Ignition for GAS BURNERS • GAS BURNERS differ in size and power. Use the diameter of the cookware to choose the most appropriate burner to cook with. [. . . ] After cleaning, rinse and dry any remaining drops of water. Gas tap maintenance Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. [. . . ]