User manual HOYT COMPOUND-2002

[. . . ] Compound Bow Owner's Manual TABLE OF CONTENTS 1. Bow Owners Personal Record. . . . . . . . . . . . . . . . . . . . . . . 2 2. Compound Bow Terminology. . . . . . . . . . . . . . . . . . . . . . . . 3 3. Important Infomation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 4. [. . . ] After the bar has been inserted fasten with the 1/4-20 x 1/2" set screws provided. (See fig 5) Hoyt USA's magnesium bows are designed with a high mount style cable guard bar that is mounted directly to the side of the 10-24 SHCS riser by two 10-24 Screws screws. (See fig 6)Prior to mounting the cable guard bar, you must remove the nylon screws used fig 6 11 only for shipping purposes. On some shorter axle to axle models, adjustable cable guard bars can be off-set too much causing the cable to track off the cam. This can cause damage to the bow or personal injury. To prevent this from happening, NEVER SET THE BAR AT THE THREE O' CLOCK POSITION. CABLE GUARD GLIDE INSTALLATION Hoyt USA uses a specially designed cable glide that has off-set cable slots. To correctly install the glide on all Hoyt models except the Excel Cam, make sure that when the cables are inserted into the glide the shortest slot is to the rear and the longer slot closest to the grip. 7 Excel Cam Glide Position Excel Cam model bows, make sure that the longest slot is to the rear and the shorter slot is closest to the grip. (See fig 7) Note: If you have trouble pulling the cables back far enough to get the glide over the end of the cable guard bar, you will need to use a bow 12 press. Hoyt USA recommends that the cable guard glide installation be done at a Pro Shop. CAUTION: Do not pull bow back without proper installation of cable guard bar and glide. TILLER ADJUSTMENT Tiller is the difference in actual distance between the upper limb to the string and lower limb to the string measured from the base of the limbs (where the limb and riser meet) at a 90 degree angle. (See fig 8) Tiller Tiller Tiller Tiller fig. 9 13 Redline cam models must be measured from a reference line from axle to axle. (See fig 9) The main function of tiller is to allow the archer to more easily and comfortably aim during the draw and release of the shot. Most bows will shoot best with an even tiller which means the distance from the string to the limb is the same on top and bottom. Tiller adjustments are made by adjusting either limb weight adjustment bolt. Example: Too much tiller on the bottom limb, decrease the weight on the top limb or increase the weight on the bottom. Hoyt USA recommends that you initially set tiller equal top and bottom. CENTERSHOT Centershot is the alignment of the arrow in the power path of the string. This is accomplished by moving the arrow rest left or right. [. . . ] ACCESSORIES All Hoyt USA sights (excluding sight pins), arrow rests, and bow quivers (excluding hood foam and arrow gripper) are warranted 100% for the life of the product to the original owner. You must have the following items in order to obtain warranty work: 1. A dated proof of purchase (sales receipt). Products must be purchased through a Hoyt USA authorized dealer (no exceptions!) 3. [. . . ]