User manual HP DESKJET 400

[. . . ] DeskJet 400 Series Printer User's Guide ENGLISH Acknowledgments ColorSmart is a trademark of Hewlett-Packard Company. registered trademark of Microsoft Corporation. Windows is a trademark of Microsoft Corporation. Table of Contents 1 Getting Started Packing List. 1 STEP 1: Connecting the Power Adapter . [. . . ] If the three lights still blink, call the Customer Support Center. 6. Grip the jammed paper firmly by its sides and pull it out slowly. When Paper Is Jammed in the Printer To clear the paper jam, perform the following steps: 1. Remove the paper from the paper tray. 7. After clearing the paper jam, close the paper separator. 3. Re-attach the printer door by first placing the door flat on the paper tray. Then align the hinges on the printer door with the pins on the printer. Press the printer door down until the printer door clicks into place. Remove the printer door by grasping it by its sides and then pulling the door up. (Use your thumbs to hold down the printer while pulling the door. ) 9. Load paper and try printing again. 10 When Paper Is Not Loading Paper does not feed into the printer properly. s Printing is slanted on the A4 size paper. s Re-load the paper. See page 2, "STEP 3: Loading Paper. " You are printing on a US Letter size paper, but the paper size selector (A4 / LTR) is set to A4. Or you are printing on an A4 size paper, but the paper size selector (A4 / LTR) is set to LTR (US Letter). Adjust the paper size selector (A4 / LTR) according to the paper size. Some paper in the stack may be of a different type, size, and weight. Make sure the paper in the stack are of the same type, size, and weight. s You are printing on an A4 size paper, but the paper size selector (A4 / LTR) is set to LTR (US Letter). Switch the paper size selector (A4 / LTR) to A4. Paper is not fed into the printer properly. See page 2, "STEP 3: Loading Paper. " s Printing is slanted on the Legal size paper, envelope, label, or thick paper. The Legal size paper, envelope, label, or thick paper is not fed into the printer properly. Push evenly the Legal size paper, the envelope, or the thick paper into the back of the printer until the printer pulls in the paper. See page 5, "Loading Other Size Paper. " s s s Legal size paper, envelope, label, or thick paper does not advance into the printer. Legal size paper, envelope, label, or thick paper should be loaded from the back of the printer, one at a time. Push evenly the Legal size paper, envelope, label, or thick paper into the back of the printer until the printer pulls in the paper. See page 5, "Loading Other Size Paper. " Paper does not eject from the printer. s Paper is jammed in the printer. [. . . ] HP's limited warranty covers only those defects which arise as a result of normal use of the product, and do not apply to any: a. Software or interfacing not supplied by HP; c. Operation outside the product's environmental specifications, including duty cycle abuse or use of a mechanical switchbox without a designated surge protector; e. Use of non-supported printing media or memory boards; or f. [. . . ]