User manual HP JETDIRECT PN1050 SETUP GUIDE

[. . . ] HP Jetdirect pn1050 Network Projector Manager Setup Guide © Copyright 2005 Hewlett-Packard Development Company, L. P. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained in this document is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. [. . . ] Do not block any vents, controls, or access panels on the projector. Make sure the cables from the module do not interfere with controls or access panels on the projector. 2. Peel the backing paper off one side of an attachment strip. Note Do not separate the two halves of the strip. 3. Attach the strip along the top or bottom edge of the label on the bottom of the server module. Press firmly to get full adhesion. Note Do not cover the module's serial number. 4. Attach the other strip to the opposite edge of the label as described above. Clean the projector or other surface where you intend to mount the module. Installing the HP Jetdirect Module 8 6. Peel the backing paper from the exposed sides of the two attachment strips. Press the module firmly onto the mounting surface so that the attachment strips adhere properly. To remove the module, gently pull it away from its mounting surface so that the halves of the attachment strips separate. To reattach the module, press it back into place so that the strips reattach. Note As an alternative, you can mount the module to a wall or other solid surface using the two keyhole slots in the bottom of the module. Insert two screws into the surface 33 mm (1­5/16 in) apart, then slide the keyhole slots over the heads of the screws. Installing the HP Jetdirect Module 9 Finding the Network Address Use the HP projector's on-screen menu to find the network address assigned to the server module and projector: 1. Open the on-screen menu by pressing the enter or menu button on the projector or its remote control. Go to the Help screen and find the IP address, which consists of four numbers separated by dots, such as 10. 2. 3. 4. Installing the HP Jetdirect Module 10 3 Managing HP Projectors Configuring the Module and Projector You can use the server module to configure and monitor the projector from a remote location on the network. Using your computer, you can perform tasks such as these: Configure the server module's network settings. Receive email notifications when certain conditions or events occur on the projector. Set security options to require passwords, encrypt data, and control access. Upgrade the firmware on the projector and server module. For complete information about managing projectors, see the Administrator's Guide on the Documentation CD. Using a Web Browser Each projector server module contains an embedded Web server, which acts as a Web site from which you can remotely configure various settings on the the server module and projector and check their status. On the projector, open the on-screen menu, go to the Help menu, and note the IP address shown on the main menu screen. The address consists of four numbers separated by dots, such as 10. 2. 3. 4. On a networked computer, open an internet browser, enter the IP address of the projector in the URL bar (for example, type 10. 2. 3. 4 or http://10. 2. 3. 4), and press the Enter key. 11 3. [. . . ] Unplug and reconnect power to the server module. Wait at least 15 seconds, then check the indicator lights on the module: If the power/status light is flickering irregularly and the USB/projector light is solid green, the setup is good. Any other light condition indicates a possible problem. See "Indicator Lights" on page 14. Fixing Problems 15 Resetting to Factory Defaults The server module retains its configuration settings in memory, even while power is removed. [. . . ]