User manual HP LASERJET 1300

[. . . ] hp LaserJet 1150 1300 1300n use hp LaserJet 1150 and hp LaserJet 1300 series printer user guide Copyright Information Copyright Hewlett-Packard Company 2003 All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. A user of the Hewlett-Packard printer associated with this user guide is granted a license to: a) print hard copies of this user guide for PERSONAL, INTERNAL or COMPANY use subject to the restriction not to sell, re-sell or otherwise distribute the hard copies; and b) place an electronic copy of this user guide on a network server, provided access to the electronic copy is limited to PERSONAL, INTERNAL users of the Hewlett-Packard printer associated with this user guide. The information contained in this document is subject to change without notice. [. . . ] You can continue printing. Make sure that you have loaded the correct media. To continue printing, press and release the Go button. If you do not want to be in manual feed mode, change the setting from your printer properties. See Printer properties (driver) for more information. The page being printed might be too complex for the printer's memory capacity. To continue printing, press and release the Go button. See Understanding print quality settings for more information. See Installing a memory DIMM (1300 series only) for more information. Door open, media out, no print cartridge, or media jam The printer is in an error state that requires operator intervention or help. Check the following: The print cartridge door is completely closed. See Loading media into the input trays for instructions. The print cartridge is correctly installed in the printer. See Changing the print cartridge for instructions. The left side panel is completely closed. 72 Chapter 6 ENWW Control panel light message (continued) Light status Condition of the printer Action No action is necessary. Printer initialization/Cancel Job/Cleaning Mode A printer initialization is taking place. If all lights blink for 1/2 of a second or longer in a sequence: the printing is initializing all previously sent print jobs are being purged a cleaning page is being printed Fatal error All lights are on. Turn the printer off and then back on. Unplug the printer for 5 minutes, and then plug it back in. If the printer still has an error, Contact HP support. Accessory error All lights are blinking. Remove the DIMMs and replace if necessary. See Installing a memory DIMM (1300 series only) for instructions. Contact HP support. Return to Finding the solution. ENWW Status light patterns 73 Common Macintosh problems Choose the item that best describes the problem: Problems in the Chooser Printing Errors USB Problems OS X problems Symptom Possible Cause Solution Problems in the Chooser LaserWriter icon does not Software not installed appear in the Chooser. (HP LaserJet 1300 series) The LaserWriter 8 driver should be present as a part of the Mac OS. Make sure that the LaserWriter driver is in the Extensions folder within the systems folder. If not, install the LaserWriter driver from your Mac OS CD. Reinstall the software. The HP LaserJet printer The software was not driver icon does not appear installed properly. [. . . ] In a DHCP environment, a DHCP server allocates IP addresses as computers and printers on the network need them. DHCP-supplied addresses are dynamic and might cause problems for computers and printers, which expect IP addresses to be static. If your print server acquired its IP address via DHCP, the IP address might have changed after you set up the printer. In this case, the printer is no longer available to the network. [. . . ]