User manual HP LASERJET 2200

[. . . ] hp color LaserJet xxxx user guide hp LaserJet 2200 hp LaserJet 2200 series printers User Guide Copyright and License Copyright Hewlett-Packard Company 2001 All Rights Reserved. Except as allowed by copyright laws or herein, reproduction, adaptation, or translation without prior written permission is prohibited. A user of the Hewlett-Packard printer associated with this user guide is granted a license to: a) print hard copies of this user guide for PERSONAL, INTERNAL or COMPANY use subject to the restriction not to sell, re-sell or otherwise distribute the hard copies; and b) place an electronic copy of this user guide on a network server, provided access to the electronic copy is limited to PERSONAL, INTERNAL users of the Hewlett-Packard printer associated with this user guide. Part number:C7058-90956 Second Edition, October 2001 Warranty The information contained in this document is subject to change without notice. [. . . ] Print job prints on both sides of the paper. Duplex may be selected in the See Accessing the Printer printer driver. Driver to find out how to access your printer driver or refer to your online help. The sealing tape may still be in Remove the toner cartridge the toner cartridge. Check the printer by pressing GO to print a demo page. Check file to make sure that it does not contain blank pages. Pages print, but are totally blank. ENWW Chapter 4 Problem Solving 73 Troubleshooting General Printing Problems (continued) Symptom Possible Cause Solution Disconnect the printer cable and reconnect it. If possible, attach the cable and printer to another computer and try a print job that you know works. Finally, try a new cable. The printer prints, but the text The printer cable is loose or is wrong, garbled, or defective. incomplete. The printer is on a network or Disconnect the printer from sharing device and is not the network and attach it receiving a clear signal. directly to a computer with a parallel or USB cable. The wrong driver was selected Check the software's printer in the software. selection menu to make sure that the HP LaserJet 2200 is selected. The software application is malfunctioning. Try printing a job from another application. If printing from Windows (any version), exit to a DOS prompt and verify functionality with the following command: At a C:\prompt, type Dir LPT1 then press enter. (This assumes the printer is connected to LPT1). If the Go light comes on, press the GO button to print and eject the page. If the page prints correctly, then the operating system is malfunctioning. If paper is already added, press and release the GO button. The printer does not respond The printer may be in manual when "print" is selected in the feed mode (Attention light software. blinking and Go light on). 74 Chapter 4 Problem Solving ENWW Troubleshooting General Printing Problems (continued) Symptom Possible Cause Solution The printer does not respond The cable between the Disconnect and reconnect the when "print" is selected in the computer and the printer is not cable. connected properly. The printer cable is defective. If possible, attach the cable to another computer and print a job you know works. You may also try using a different cable. [. . . ] The PCL 6 printer commands take full advantage of the printer's features. HP-GL/2 The printer has the ability to print vector graphics using the HP-GL/2 graphics language. Printing in the HP-GL/2 language requires that the printer leave PCL language and enter HP-GL/2 mode, which can be done by sending the proper PCL codes. Some software applications switch languages through their drivers. ENWW Appendix D Printer Commands 147 PJL HP's Printer Job Language (PJL) provides control above PCL and other printer languages. The four major functions provided by PJL are: printer language switching job separation printer configuration status readback from the printer PJL commands may be used to change printer default settings. [. . . ]