User manual HP LASERJET PRO 200 COLOR M251N (CF146A)

[. . . ] LASERJET PRO 200 COLOR User Guide M251n M251nw HP LaserJet Pro 200 color M251 Series Printer User Guide Copyright and License © 2012 Copyright Hewlett-Packard Development Company, L. P. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. [. . . ] If you need to make changes, use the product control panel. NOTE: The setting must match with the network product to which you are connecting (a network hub, switch, gateway, router, or computer). NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle. Link speed and duplex settings (LCD control panel) NOTE: This section applies to the HP LaserJet Pro 200 color M251n Printer model only. On the control panel, press the OK button. Use the arrow buttons to select the Network Setup option, and then press the OK button. Use the arrow buttons to select the Link Speed option, and then press the OK button. Use the arrow buttons to select one of the following settings. Setting Automatic 10T Half 10T Full 100TX Half 100TX Full Description The print server automatically configures itself for the highest link speed and communication mode allowed on the network. 10 megabytes per second (Mbps), half-duplex operation 10 Mbps, full-duplex operation 100 Mbps, half-duplex operation 100 Mbps, full-duplex operation 5. Press the OK button. The product turns off and then on. Link speed and duplex settings (touchscreen control panel) NOTE: This section applies to the HP LaserJet Pro 200 color M251nw Printer model only. From the Home screen on the product control panel, touch the Setup Scroll to and touch the Network Setup menu. button. 60 Chapter 4 Manage and maintain the product ENWW Setting Automatic 10T Half 10T Full 100TX Half 100TX Full Description The print server automatically configures itself for the highest link speed and communication mode allowed on the network. 10 megabytes per second (Mbps), half-duplex operation 10 Mbps, full-duplex operation 100 Mbps, half-duplex operation 100 Mbps, full-duplex operation 5. Touch the OK button. The product turns off and then on. ENWW Configure IP network settings 61 HP Device Toolbox (Windows) Use the HP Device Toolbox for Windows to view or change product settings from your computer. This tool opens the HP Embedded Web Server for the product. NOTE: This tool is available only if you performed a full installation when you installed the product. Click the Start button, and then click the Programs item. Click your HP product group, and then click the HP Device Toolbox item. Description ● Device Status: Shows the product status and shows the approximate percent life remaining of HP supplies. Supplies Status: Shows the approximate percent life remaining of HP supplies. Consider having a replacement supply available to install when print quality is no longer acceptable. The supply does not need to be replaced unless the print quality is no longer acceptable. Device Configuration: Shows the information found on the product configuration page. [. . . ] Make sure that you do not have too many USB devices drawing power from the chain. Disconnect all of the devices from the chain, and then connect the cable directly to the USB port on the computer. Check to see if more than two non-powered USB hubs are connected in a row on the chain. Disconnect all of the devices from the chain, and then connect the cable directly to the USB port on the computer. [. . . ]