User manual HP LT3200 32 INCH PROFESSIONAL LCD HDTV

[. . . ] The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. hP shall not be liable for technical or editorial errors or omissions contained herein. HP assumes no responsibility for the use or reliability of its software on equipment that is not furnished by HP. [. . . ] For more information about defining the picture settings, see "Using the Picture Menu" on page 31. Press the Last button on the remote control to view the previous channel that you viewed. You can quickly select a favorite channel by using the Fav button on the remote control. Press the Fav button on the remote control to view a list of your favorite channels. Press an arrow button to select a channel from the list, and then press OK. The first time you open the favorites list, or after using the Setup Wizard or Auto Scan in the onscreen display Channel menu, the Fav list is empty. During the first-time Setup Wizard, or an Auto Scan, the TV searches for the TV antenna or cable signal sources, finds all the available channels, and adds them to the channel list. If you skipped or canceled during the initial setup, and have not run the Setup Wizard or the Auto Scan, there are no channels in the channel list. To be able to add channels to the favorites list, the channel must be in the channel list. To add a channel to the Fav list: If necessary, first run the Setup Wizard or Auto Scan in the Channel menu; see "Starting the Setup Wizard" on page 42 or see "Searching for channels" on page 34. Or Press the Source button again to close the list of input sources without changing the source. Press the Info button on the remote control to display a banner with information about the program that you are currently viewing. Sometimes the name of the program is not included in the broadcast. You can change all the labels except Antenna (or Cable). 3 Press Ch+ to use the empty line, or press an arrow Button to select a favorite channel entry that you want to change, and then press Ch+. The label shows the scan source selection (Antenna or Cable) of the last channel scan performed by either the Setup Wizard or the Channel menu. Auto automatically shows the correct aspect ratio, based on the content. 16:9 shows widescreen TV in its recorded format, or stretches a 4:3 ratio image to fit the screen with no center aspect correction. 4:3 shows the standard 4:3 ratio image in the center of the TV, with dark bars on the left and right of the screen, or horizontally shrinks widescreen pictures. Suitable for stretching widescreen DVD movies to reduce or eliminate horizontal dark stripes at the top and bottom of the screen. Zoom2 stretches the image both vertically and horizontally, and may clip the top, bottom, and sides of the image. Panorama stretches the picture horizontally, if necessary, to fill the screen; the center of the screen has aspect correction. [. . . ] The picture, with a component input source connected, is too red, blue, or green, or it has black that is too black or washed out. Symptom Part of the picture is cut off, or the picture is not centered. The picture image is too large or too small. The picture has dark side bars and I cannot remove the bars by choosing a different aspect ratio. [. . . ]