User manual HP PAVILION F70

[. . . ] Notice Important Safety Instructions What the f50 Monitor Offers What the f70 Monitor Offers Unpacking the Monitor Setting Up the Monitor How to Install the Drivers Adjusting the Monitor Using the Monitor Troubleshooting LCD Monitor Quality and Pixel Policy for f50 Monitor hp pavilion f50/f70 D5063/D5064 15-inch/17-inch LCD Monitor User's Guide LCD Monitor Quality and Pixel (15-inch/17-inch Viewable Image) Policy for f70 Monitor Technical Specifications for the f50 Monitor Technical Specifications for the f70 Monitor HP f70 Audio System Performance Specifications Care and Cleaning Environmental Information Regulatory Information X hp pavilion f50/f70 LCD Monitor Notice Notice The information contained in the documents accompanying this product is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HP shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. HP assumes no responsibility for the use or reliability of its software on equipment that is not furnished by HP. [. . . ] The setting is automatically saved as you adjust it. 2 When the screen is in the horizontal position you want, press the Menu button to exit the setting screen. To adjust OSD V Position: You can adjust the vertical position of the OSD (Display Manager) screen. 1 Press the Browse buttons to position the OSD screen. The setting is automatically saved as you adjust it. 2 When the screen is in the vertical position you want, press the Menu button to exit the setting screen. Mode Recall Using Mode Recall restores original factory settings for Color, Brightness, Phase, and Clock. This will re-establish default color settings for the best possible brightness. To use Mode Recall: 1 Open the Mode Recall setting screen. See "Using Display Manager" on page 24. A window with a red bar appears. 2 Press the Select button to proceed with Mode Recall, or press the Menu button to exit without resetting. 3 If you reset with Mode Recall, press the Menu button to exit the setting screen. X 31 hp pavilion f50/f70 LCD Monitor Using the Monitor Backlight Info The Backlight Info window shows the elapsed time of usage for the light behind the display screen. The expected lifespan of the backlight is approximately 30, 000 to 40, 000 hours. At some point after the maximum usage time of the backlight has been exceeded, you may notice a decrease in brightness of up to 50%. At this point, the backlight needs to be replaced to restore full brightness. CAUTION: The backlight can be replaced only by a trained technician. Please contact the HP Support Center for assistance. Do not attempt to replace the light yourself. NOTE: Do not use a screen saver with the LCD monitor, as the backlight will be used. It is recommended that you enable an automatic power saving mode, or switch off the monitor when not in use. To view Backlight Info: 1 Open the Backlight Info setting screen. See "Using Display Manager" on page 24. 2 Press the Menu button to exit the setting screen. Serial Number You may need to provide the display serial number to HP Support technicians to help them serve you better during a Support call. To view a Serial Number: 1 Open the Serial Number setting screen. See "Using Display Manager" on page 24. [. . . ] The complete environmental criteria document may be ordered from: TCO Development SE-114 94 Stockholm, Sweden Fax: +46 8 782 92 07 Email (Internet): development@tco. se Current information regarding TCO '99 approved and labeled products may also be obtained over the Internet, using the address: http://www. tco-info. com/ X 47 hp pavilion f50/f70 LCD Monitor R e g u l a t o r y I nf o r m a t i o n Environmental requirements Flame retardants: Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at least to delay, the spread of fire. Up to 30% of the plastic in a computer casing can consist of flame retardant substances. Most flame retardants contain bromine or chloride, and those flame retardants are chemically related to another group of environmental toxins, PCBs. [. . . ]