User manual HP PHOTOSMART C3100 Basics Guide

[. . . ] HP Photosmart C3100 All-in-One series Basics Guide HP Photosmart C3100 All-in-One series Basics Guide 2006 Hewlett-Packard Development Company, L. P. Adobe and the Acrobat logo are trademarks of Adobe Systems Incorporated. Windows, Windows NT, Windows ME, Windows XP, and Windows 2000 are U. S. registered trademarks of Microsoft Corporation. Intel and Pentium are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. [. . . ] Clean the glass Clean the lid backing 16 HP Photosmart C3100 All-in-One series Clean the glass Glass that is dirty from fingerprints, smudges, hair, and dust on the main glass surface slows down performance and affects the accuracy of some features. Turn off the HP All-in-One, unplug the power cord, and raise the lid. Clean the glass with a soft cloth or sponge slightly moistened with a nonabrasive glass cleaner. Caution Do not use abrasives, acetone, benzene, or carbon tetrachloride on the glass, since they can damage it. Do not place or spray liquid directly on the glass. The liquid might seep under the glass and damage the device. Dry the glass with a dry, soft, lint-free cloth to prevent spotting. Plug in the power cord, and then turn on the HP All-in-One. HP All-in-One overview Clean the lid backing Minor debris can accumulate on the white document backing located underneath the lid of the HP All-in-One. Turn off the HP All-in-One, unplug the power cord, and raise the lid. Clean the white document backing with a soft cloth or sponge slightly moistened with a mild soap and warm water. Wash the backing gently to loosen debris. Dry the backing with a dry, soft, lint-free cloth. Caution Do not use paper-based wipes, as these might scratch the backing. If further cleaning is needed, repeat the previous steps using isopropyl (rubbing) alcohol, and wipe the backing thoroughly with a damp cloth to remove any residual alcohol. Caution Be careful not to spill alcohol on the glass or exterior of the HP All-in-One, as this might damage the device. Plug in the power cord, and then turn on the HP All-in-One. Basics Guide 17 2 Troubleshooting and support This chapter contains troubleshooting information for the HP All-in-One. Specific information is provided for installation and configuration issues, and some operational topics. For more troubleshooting information, see the onscreen Help that came with your software. Many issues are caused when the HP All-in-One is connected to the computer using a USB cable before the HP All-in-One software is installed on the computer. If you connected the HP Allin-One to your computer before the software installation screen prompts you to do so, you must follow these steps: Troubleshooting common setup issues Troubleshooting and support 1. 5. Disconnect the USB cable from the computer. Uninstall the software (if you have already installed it). [. . . ] If HP is unable to repair or replace, as applicable, a defective product which is covered by HP's warranty, HP shall, within a reasonable time after being notified of the defect, refund the purchase price for the product. HP shall have no obligation to repair, replace, or refund until the customer returns the defective product to HP. Any replacement product may be either new or like-new, provided that it has functionality at least equal to that of the product being replaced. HP products may contain remanufactured parts, components, or materials equivalent to new in performance. [. . . ]