User manual HP PHOTOSMART C4150 Basics Guide

[. . . ] HP Photosmart C4100 All-in-One series Basics Guide HP Photosmart C4100 All-in-One series Basics Guide © 2006 Hewlett-Packard Development Company, L. P. Adobe® and the Acrobat logo® are trademarks of Adobe Systems Incorporated. Windows®, Windows NT®, Windows ME®, Windows XP®, and Windows 2000® are U. S. registered trademarks of Microsoft Corporation. Intel® and Pentium® are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. [. . . ] Dry the glass with a dry, soft, lint-free cloth to prevent spotting. Plug in the power cord, and then turn on the HP All-in-One. Clean the lid backing Minor debris can accumulate on the white document backing located underneath the lid of the HP All-in-One. Turn off the HP All-in-One, unplug the power cord, and raise the lid. Clean the white document backing with a soft cloth or sponge slightly moistened with a mild soap and warm water. Wash the backing gently to loosen debris. Dry the backing with a dry, soft, lint-free cloth. Caution Do not use paper-based wipes, as these might scratch the backing. If further cleaning is needed, repeat the previous steps using isopropyl (rubbing) alcohol, and wipe the backing thoroughly with a damp cloth to remove any residual alcohol. Caution Be careful not to spill alcohol on the glass or exterior of the HP All-in-One, as this might damage the device. Plug in the power cord, and then turn on the HP All-in-One. 16 HP Photosmart C4100 All-in-One series 2 Troubleshooting and support This chapter contains troubleshooting information for the HP All-in-One. Specific information is provided for installation and configuration issues, and some operational topics. For more troubleshooting information, see the onscreen Help that came with your software. Many issues are caused when the HP All-in-One is connected to the computer using a USB cable before the HP All-in-One software is installed on the computer. If you connected the HP Allin-One to your computer before the software installation screen prompts you to do so, you must follow these steps: Troubleshooting common setup issues 1. Disconnect the USB cable from the computer. Uninstall the software (if you have already installed it). Turn off the HP All-in-One, wait one minute, then restart it. Caution Do not connect the USB cable to the computer until prompted by the software installation screen. For support contact information, see the inside back cover of this guide. Troubleshooting and support Uninstall and reinstall the software If your installation is incomplete, or if you connected the USB cable to the computer before prompted by the software installation screen, you might need to uninstall and then reinstall the software. Do not simply delete the HP All-in-One application files from your computer. Make sure to remove them properly using the uninstall utility provided when you installed the software that came with the HP All-in-One. [. . . ] If HP is unable to repair or replace, as applicable, a defective product which is covered by HP's warranty, HP shall, within a reasonable time after being notified of the defect, refund the purchase price for the product. HP shall have no obligation to repair, replace, or refund until the customer returns the defective product to HP. Any replacement product may be either new or like-new, provided that it has functionality at least equal to that of the product being replaced. HP products may contain remanufactured parts, components, or materials equivalent to new in performance. [. . . ]