User manual HP PROLIANT ML110 G5 STORAGE SERVER RACK RAIL KIT INSTALLATION INSTRUCTIONS (464164-001, FEBRUARY 2008)

[. . . ] HP Rack Rail Kit installation instructions Overview This document contains instructions for installing HP rack rails into square and round hole racks for HP 1U and 2U servers. NOTE: For more information on preparing the server for installation, see the user guide that ships with the server. Kit contents · Two rack rails (left and right) · Mounting hardware for square and round hole racks · Two tie wraps NOTE: If mounting the server into threaded hole or telco racks, please see www. racksolutions. com to purchase mounting hardware. Important safety information See the Important Safety Information document included with the server. © Copyright 1999, 2008 Hewlett-Packard Development Company, L. P. [. . . ] Ensure that the rack is level and stable before working on the rack. Be sure the leveling jacks (feet) extend to the floor and that the full weight of the rack rests firmly on the floor. NOTE: If installing rails into a square hole rack, use larger-sized shoulder screws and pins for mounting. If installing rails into a round hole rack, use smaller-sized shoulder screws and pins for mounting. WARNING!Ensure that the rack has anti-tip measures in place. Such measures may include floor-bolting, anti-tip feet, ballast, or a combination of these as specified by the rack manufacturer and applicable codes. WARNING!Ensure that sufficient personnel are on hand to support the product(s) during the installation process. Use of the appropriate lifting device is recommended as an installation aid. WARNING!Always load the rack from the bottom up. Load the heaviest items in the rack first. This makes the rack bottom-heavy and helps prevent it from becoming unstable. 3. Figure 1 Attach the rails to the rack columns Slide the server into position on the rails (step 3 in Figures 2, 3). NOTE: The rear ends of the rails have a CTO bracket that must overlap the chassis tab in order to secure the server to the rails (Figure 4). WARNING! [. . . ] Secure the server to the rack rails using thumbscrews on the server front bezel (step 4 in Figures 5, 6). Figure 7 Cable management with tie wraps Connect all power cords. Page 3 [. . . ]