User manual HP PSC 700 ALL-IN-ONE

[. . . ] No part of the document may be photocopied, reproduced, or translated to another language without the prior written consent of Hewlett-Packard Company. WARNING To prevent fire or shock hazard, do not expose this product to rain or any type of moisture. Always follow basic safety precautions when using this product to reduce risk of injury from fire or electric shock. wARNING: Potential Shock Hazard 1 Read and understand all instructions in the Setup Poster. [. . . ] All copy settings selected on the front panel are reset two minutes after the unit completes the copy job unless you save the settings as the default settings. Settings that you set in the software's Copy dialog box are reset immediately after you process the job. (Settings changed in the software's Copy Settings dialog box remain in effect until you change them again. For more information, see "Change settings for all future copy jobs" in the Onscreen Guide. Follow these steps to start a copy job from your unit. If you are using anything other than plain paper, press Paper Type until the appropriate type appears. For more information, see "Load paper or transparency film, or load originals". If you want to make more than one copy (the default), press Number of Copies, or if number of copies is displayed, press or until the number of desired copies appears. For more information, see "Set the number of copies" in the Onscreen Guide. Follow these steps to start a copy job from your computer. 1 2 3 Load the input tray with the appropriate paper. For more information, see "Load paper or transparency film, or load originals". You can reduce or enlarge a copy of an original using predefined settings, such as Fit to Page, Poster, or wallet by selecting your own reduction/enlargement percentages. These settings are available through the Creative Copying feature. If the margins of your full-size original are smaller than the minimum margin settings supported by your unit, they will be cut off during the copy process. to obtain a full copy of a full-size original , select Custom 100%. You can also use the Fit to Page feature (for more information on this feature, see "Make copies automatically fit"). If you place your original on the glass, correct placement is very important in achieving the desired results for features such as Fit to Page. for more information , see "Load originals on the glass. " To do this using the front panel 1 Press Creative Copying, then press until the setting you want appears. 2 3 Press Enter to select the desired size. If the option you selected supports multiple copies on a single page as indicated by , select the number of copies that will be printed on a page by pressing or until the desired number of copies on a page appears. [. . . ] 2 Reset your unit: a Turn off the unit using the On button located on the unit's front panel. B Unplug the power adapter connector from the back of the unit. C Plug the power adapter connector back into the unit. 4 If you are still experiencing problems and need to speak with an HP Customer Support Representative: · Have your serial number and service ID ready. [. . . ]