User manual HP STORAGEWORKS 400 ALL-IN-ONE STORAGE SYSTEM STORAGEWORKS 400 ALL-IN-ONE STORAGE SYSTEM RAIL INSTALLATION INSTRUCTIONS (4346

[. . . ] HP StorageWorks 400 All-in-One Storage System rail installation instructions Important Safety Information Læs dokumentet Vigtige sikkerhedsoplysninger på dokumentations-cd'en, før produktet installeres. Prima dell'installazione, leggere sul CD le Informazioni importanti sulla sicurezza. Les "Viktig sikkerhetsinformasjon" på dokumentasjons-CDen før du installerer dette produktet. Tärkeisiin turvatietoihin" Documentation CD -levyllä ennen tuotteen asentamista. Läs dokumentet Viktig säkerhetsinformation på dokumentations-cd:n innan du installerar denna produkt. About this document Printed on at least 50% total recycled fiber with at least 10% post-consumer paper. This document provides procedures for installing the HP StorageWorks 400 All-in-One Storage System (AiO400) into a rack using the rails provided. HP assumes that you are qualified in servicing computer equipment, and trained in recognizing hazards in products with hazardous energy levels. © Copyright 2006 Hewlett-Packard Development Company, L. P. [. . . ] Verify that the total current of the rack components does not exceed the current rating of the power distribution unit or outlet receptacles. IMPORTANT: HP recommends leaving the rail mounting screws loose until the server is completely installed. This eases installation by preventing binding of the server in the rack. Rack planning procedures The rack resource kit ships with all HP branded or Compaq branded 9000, 10000, and H9 series racks. For more information on the content of each resource, see the rack resource kit documentation. If you intend to deploy and configure multiple servers in a single rack, refer to the white paper on high-density deployment at the following HP web site: http://www. hp. com/products/servers/platforms. NOTE: Install the two rails to the sides of the rack. Align holes at the other end of the rack with the rail assembly and secure with mounting hardware. Install the other side rail assembly on the other side of the rack as described in the previous steps. Locate the inner slide rails: · If the rail assembly you mounted in the rack comes as one unit, remove the inner slide rails from the outer slide rails. To do so, extend the inner slide rails from the front of the rack until they lock in place. Then, press the inner rail release latch, as shown, and pull the inner slide rails straight out. The two rail assemblies packed in a kit are identical, but depending on the which side of the rack they are installed, each are rotated so the sliding portions of the rails are towards the center of the rack. a. Adjust the side rail assemblies to the approximate rack depth. At one side of the rack, align the rail holes with the holes in the rack and secure with the provided mounting hardware. · If the inner slide rails in your kit are separate from the rail assemblies installed in the racks, remove them from the kit box and proceed to the next step. Server preparation 1. Attach the two bezel brackets to the server using the supplied bracket screws, as shown (1). Attach an inner slide rail (locking latches facing out) to each side of the server by placing the rail over the server standoffs and sliding the rail toward the rear of the server. [. . . ] Push the AiO400 fully into the rack (1). Insert a screw into each bezel bracket and tighten to secure the server to the rack (2). To complete the preparation of your AiO400 for operation, see the HP StorageWorks 400 All-in-One Storage System installation guide that is included with your product. [. . . ]