User manual HP STORAGEWORKS 4000/6000/8000 ENTERPRISE VIRTUAL ARRAYS

[. . . ] EZPilotTM EVA Version 2. 0 User Manual Copyright© 2007 Emulex Corporation. No part of this document may be reproduced by any means nor translated to any electronic medium without the written consent of Emulex Corporation. Information furnished by Emulex Corporation is believed to be accurate and reliable. However, no responsibility is assumed by Emulex Corporation for its use; or for any infringements of patents or other rights of third parties which may result from its use. [. . . ] Click Apply. Viewing a Logical Drive's Disk Details Using the Logical Drive Summary page you can view the information about the logical drive's disk. You can view disk details such as the disk's name, bus slot, status, health, size and so on. To view a logical drive's disk details: 1. Do one of the following: · · From the Menu bar, click View, then click Storage Devices. From the Toolbar, click the Storage View button. 2. From the discovery-tree, select the logical drive whose disk details you wish to view. The Logical Drive Summary page is displayed. The Logical Drive Disks page appears. Figure 20: The Logical Drive Disks page Expanding a Logical Drive Using the Logical Drive Summary page you can expand a logical drive. Do one of the following: · · From the Menu bar, click View, then click Storage Devices. From the Toolbar, click the Storage View button. 2. From the discovery-tree, select the logical drive you wish to expand. The Logical Drive Summary page is displayed. Click Expand. EZPilot - Management Section Page 24 Or Right-click on the selected logical drive in the discovery-tree and select Expand. The Expand Logical Drive dialog box appears. Figure 21: The Expand Logical Drive dialog box 3. Enter the amount to increase the storage capacity on the drive. The maximum expansion amount is displayed on the dialog box. The units drop down box next to the Enter Expansion Amount field can be used to change the size units. The size can be displayed in gigabytes or terabytes (if more than 1 terabyte is available). Click OK. Note: If there is already a file system defined on the logical drive, expanding the logical drive will not expand the file system. You must use a disk management tool to expand the file system after the logical drive is expanded. 4. A dialog box appears informing you that the logical drive was expanded. Click OK. Note: It may take several minutes for the new logical drive size to appear on the Logical Drive Summary page. EZPilot - Management Section Page 25 Viewing Target Information Selecting an unmanaged target (for example, a tape device) or selecting a controller port under a storage device in Host or Switch views displays the Target Information page. Figure 22: The Target Information page The Target Information page displays the following information: · · · · · · FC ID - The FC identifier for the target which is assigned automatically in the firmware. [. . . ] Click Save after you have done this for each disk. Close Command View and open EZPilot Manager. Click on the storage array in the discovery tree and click Physical Disks in the right pane. All drives on both the first and second disk shelves will now be listed and available for LUN allocation. Adding New Disks to the Existing Default Disk Group All of the new disks must be of the same type (FC or FATA) as those in the default disk group. [. . . ]