User manual HUBBELL LIGHTING DS-WP-X

[. . . ] Çamaþýr makinesinin ambalajdan çýkartýlmasý 2. Çamaþýr makinesinin taþýma esnasýnda hasar görmemiþ olduðunu kontrol ediniz. Hasar görmüþ ise monte etmeyiniz ve yetkili satýcýyla temas kurunuz. Taþýma esnasýnda güvenliði saðlayan üç adet koruma vidasýný sökünüz ve üst kýsýmdaki plastik separatörü çýkartýnýz (resime bkz. ). A 1. [. . . ] Su musluðu açýk deðil. BAÞLAT/TEKRAR BAÞLAT düðmesine basýlmadý. Taným Çamaþýr makinesi su almýyor. Programlar Çamaþýr makinesi devamlý su alýp veriyor. • Boþaltma hortumu zeminden 65 ile 100 cm arasýnda yerleþtirilmemiþ (bkz. • Boþaltma hortumu suya girmiþ (bkz. • Duvardaki tahliyenin hava boþluðu yok. Bu kontrollerdan sonra olumlu sonuç alýnamazsa, musluðu kapatýp, çamaþýr makinesini durdurarak Ariston Yetkili Servisine haber veriniz. Oturduðunuz kat binanýn üst katlarýndaysa, sifon etkisi sebebiyle çamaþýr makinesi devamlý su alýp, veriyor olabilir. Bu sorunun çözümü için piyasada sifon önleyici valfler satýlmaktadýr. • Program su boþaltmayý öngörmüyor: bazý programlarda su boþaltma iþlemini elle müdahale ederek baþlatmak gerekir (bkz. • Kolay ütü fonksiyonu devrede: program sürecini tamamlamak için BAÞLAT/TEKRAR BAÞLAT düðmesine basýnýz (bkz. • Boþaltma hortumu bükülmüþ (bkz. • Boþaltma kanalý týkalý. Keep all the parts: you will need them again if the washing machine needs to be moved to another location.  Packaging materials are not children's toys. Levelling 1. Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or other. If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured according to the worktop, must not exceed 2°. 3. Make sure there are no kinks or bends in the hose.  The water pressure at the tap must be within the values indicated in the Technical details table (on the next page).  If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman. 14 Connecting the drain hose  Do not use extensions or multiple sockets. Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; GB Installation  The power supply cable must never be bent or dangerously compressed.  The power supply cable must only be replaced by an authorised serviceman. Warning!The company denies all liability if and when these norms are not respected. 65 - 100 cm Description The first wash cycle alternatively, place it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater. Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, setting the 90°C programme without a pre-wash cycle. Programmes Detergents case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length. Electric connection  We advise against the use of hose extensions; in Technical details Model DS-WP-X 59. 5 cm wide 85 cm high 52. 5 cm deep from 1 to 5 kg voltage 220/230 Volts 50 Hz maximum absorbed power 1850 W maximum pressure 1 MPa (10 bar) minimum pressure 0. 05 MPa (0. 5 bar) drum capacity 46 litres Dimensions Capacity Electric connections Water connections Spin speed Precautions Before plugging the appliance into the mains socket, make sure that: • the socket is earthed and in compliance with the applicable law; • the socket is able to sustain the appliance's maximum power load indicated in the Technical details table (on the right); • the supply voltage is included within the values i ndicated on the Technical details table (on the right); • the socket is compatible with the washing machine's plug. If this is not the case, replace the socket or the plug. Care up to 1000 rpm Control programmes according to IEC456 directive programme 3; temperature 60°C; run with a load of 5 kg. This appliance is compliant with the following European Community Directives: - 73/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments - 89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments TS 2004 EN 60335-2-7 Troubleshooting  The washing machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms. socket must be within easy reach. Service  When the washing machine is installed, the mains 15 Washing machine description GB Control panel Leds FUNCTION Buttons START/STOP Button ON-OFF/DOOR LOCK l Led Detergent dispenser Button Knob PROGRAMME Knob START/RESET TEMPERATURE Detergent dispenser: to add detergent and fabric softener (see page 20). LEDS: to find out which wash cycle phase is under way. [. . . ] Do not use solvents or abrasives. Cleaning the detergent dispenser 1 Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. 2 2. unscrew the lid rotating it anticlockwise (see figure): a little water may trickle out. This is perfectly normal; Caring for your appliance door and drum • Always leave the appliance door ajar to prevent unpleasant odours from forming. [. . . ]