User manual HUBBELL LIGHTING HOOK & PLUG

[. . . ] Çamaþýr makinesinin ambalajdan çýkartýlmasý 2. Çamaþýr makinesinin taþýma esnasýnda hasar görmemiþ olduðunu kontrol ediniz. Hasar görmüþ ise monte etmeyiniz ve yetkili satýcýyla temas kurunuz. Taþýma esnasýnda güvenliði saðlayan üç adet koruma vidasýný sökünüz ve üst kýsýmdaki plastik separatörü çýkartýnýz (resime bkz. ). 4. [. . . ] Paneli takarken, tam yerleþtirmeden evvel, kancalarýn yuvalara gelip gelmediðini kontrol ediniz. Su giriþ hortumunun kontrolü Su giriþ hortumunu, en azýndan senede bir defa kontrol ediniz. Yarýk veya çatlaklar varsa deðiþtiriniz: yýkama esnasýndaki yüksek basýnçlar ani delinmelere yol açabilirler.  Kesinlikle daha önceden kullanýlmýþ hortum kullanmayýnýz.  Sorunlar ve çözümleri Çamaþýr makinesi çalýþmýyor olabilir. sayfa 12), aþaðýdaki liste yardýmýyla kolayca çözümlenecek bir sorun olup olmadýðýna bakýnýz. TR Sorunlar: Çamaþýr makinesi çalýþmýyor. Yýkama iþlemi baþlamýyor. Muhtemel nedenler / Çözümler: • Fiþ prize takýlý deðil veya tam temas etmiyor. • Kapak iyi kapalý deðil (ýþýklý göstergede DOOR ibaresi görüntüleniyor). • Düðmeye • BAÞLAT/TEKRAR BAÞLATdüðmesine basýlmadý. • Su musluðu açýk deðil. • Baþlangýç zamanýný erteleme programlanmýþ (zaman ayarý, bkz. • • • • • • Su giriþ hortumu musluða takýlý deðil. Su musluðu açýk deðil. BAÞLAT/TEKRAR BAÞLAT düðmesine basýlmadý. Montaj Taným Çamaþýr makinesi su almýyor. Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer. Remove the 3 protective screws and the rubber washer with the respective spacer, situated on the rear of the appliance (see figure). 4. Seal the gaps using the plastic plugs provided. Keep all the parts: you will need them again if the washing machine needs to be moved to another location. 1. Connect the supply pipe to the water mains using a gas 3/4 attachment, fitting the rubber gasket and the filter supplied with the appliance and ensuring that they are fimly tightened to the taps. The water supply marked C must be connected to the cold water tap; the pipe marked H must be connected to the hot water tap. Both pipes may be connected to the cold water tap using the special Y connection with multiple attachments, supplied with the appliance (see figure). Before making the connection, allow the water to run freely until it is perfectly clear. Warning: clean the filters regularly by rinsing it under running water. Connect the other end of the water inlet hose to the washing machine, screwing it onto the appliance's cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure). [. . . ] Do not use solvents or abrasives. Cleaning the detergent dispenser 1 Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. 2 2. unscrew the lid rotating it anticlockwise (see figure): a little water may trickle out. This is perfectly normal; Caring for your appliance door and drum • Always leave the appliance door ajar to prevent unpleasant odours from forming. [. . . ]