User manual HUBBELL LIGHTING MLP

[. . . ] That the inlet and draining pipes are connected correctly. Never use pipes that have already been used; 3. That the washing machine is levelled properly; something worth checking to aid the performance of your washing machine; 4. That the drum's fixing screws have been removed from the back of the washing machine. 2. [. . . ] When pouring in the bleach, be careful not to exceed the "max" level indicated on the central pivot (see illustration). The use of the additional bleach container excludes the possibility of using the pre-wash cycle. Traditional bleach can only be used on sturdy white fabrics, whereas delicate bleach can be used for coloured fabrics, synthetics and for wool. MAX MAX 2 The detergent dispenser can be removed and cleaned: just lift it up and pull it outwards , as indicated in the figure. Then leave it under running water for a few minutes. Cutting costs efficiently A guide to environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE Achieve the best use of energy, water, detergent and time by using the recommended maximum load size. SAVE up to 50% energy by washing a full load instead of 2 half loads. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. SAVE up to 50% energy by using a 60°C wash programme. SAVE energy and time by selecting a high spin speed to reduce the water content in laundry before using a drying programme. You cannot bleach with the 11 “Silk” programme and with the “special programmes” (see page 4). Should you wish to bleach separately, pour the bleach into extra compartment 4, set the rinse programme for cotton fabrics or the light rinse programme for synthetics. There could be work in progress in your building or street. If the water is very calcareous, or if work has recently been carried out on the water piping, the tap filter could be clogged with particles and debris. The tract of the rubber hose bringing water to washing machine must be as straight as possible. Make sure it is not squashed or kinked. The washing machine continuously fills and drains water. It must be installed at a height ranging from 60 to 100 cm. Is the end of the hose immersed in water?Does the wall drainage system have a breather pipe?If the problem persists even after these checks, turn the water supply off the machine and call for assistance. If you live on an upper floor of your building, there may be a problem with your drain trap. To solve this problem, a special valve must be installed. Margherita - Iinstructions for installation and use 8 M ARGHERITA The washing machine does not drain or spin. Does the selected programme incorporates water draining? [. . . ] Never pull on the supply cable or the washing machine to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high The temperatures. appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. Never force the washing machine door because this could damage the safety lock which prevents accidental opening when the nachine is working. [. . . ]