User manual HUBBELL LIGHTING QL17

[. . . ] That the inlet and draining pipes are connected correctly. Never use hoses that have already been used, always use the new ones provided with your machine. That the washer is levelled properly; something worth checking for the life of your washer and the quality of your wash; 4. That the drum's fixing screws have been removed from the back of the washer. 7. [. . . ] Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. SAVE up to 50% energy by using a 60°C wash programme. SAVE energy and time by selecting the highest suitable spin speed to reduce the water content in laundry before using a drying programme. You cannot bleach with the “Silk” programme and with the “special programmes” (see page 4). Use the stain removal button every time you want to bleach. Should you want to do it separately you must pour the bleach into the additional container 4, press button H (stain removal), start the washing machine, then select one of the symbols according to the type of fabric. When you bleach during a normal wash cycle, pour the detergent and any additives in the special compartments, press button H (stain removal), set the programme you desire and turn the washing machine on. 7 Margherita - Instructions for installation and use Troubleshooting M ARGHERITA In most cases, when your washing machine fails to work, the problems arising can be easily solved without having to call for a technician. Before calling for assistance, always check these points. Is the plug correctly inserted into the socket?It could have been moved whilst cleaning. A circuit breaker may have switched off as a result of too many electrical appliances working at the same time. Or maybe due to a general failure in your entire area. It must be installed at a height ranging from 60 to 100 cm. Is the end of the hose immersed in water?Does the wall drainage system have a breather pipe?If the problem persists even after these checks, turn the water supply off the machine and call for assistance. If you live on an upper floor of your building, there may be a problem with your drain trap. To solve this problem, a special valve must be installed. Margherita - Iinstructions for installation and use 8 M ARGHERITA The washing machine does not drain or spin. Does the selected programme incorporates water draining?Some programmes stop at the end of the wash cycles and draining will have to be selected manually. Is the “Rinse-Hold" function -where provided enabled?This function requires manual selection for draining. To check it, turn off the water supply, unplug the washing machine and follow the instructions on page 12, or call for technical assistance. [. . . ] Never pull on the supply cable or the washing machine to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high The temperatures. appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. Never force the washing machine door because this could damage the safety lock which prevents accidental opening when the nachine is working. [. . . ]