User manual HUMAX LGB-23DCNL

[. . . ] Indicates a hazardous situation which, if not avoided, could result in serious injury. This symbol indicates important instructions accompanying the LCD-TV. Read this manual carefully and make sure you understand the instructions provided. For your safety, check what the result of each action will be. Throughout the whole manual, pay special attention to the following marks that indicate hazardous situations. [. . . ] If the Channel Search is stopped or finished, press the OK ( ) button to save the result of the channel search. Once the channel search has finished, you can enjoy digital television. Warning : If you exit the Automatic Search without fully completing the channel searching procedure, you may not have any digital TV channels stored. In this case, you can use the Installation Menu to configure your LCD-TV as required. 28. Digital TV Channel Setup 2. Basic Operation This chapter describes functions such as switching channel, changing language, and basic features for watching programmes. 2. 1 Switching Channel You can switch the current channel using one of the following methods. 1. Enter your desired channel number using the NUMERICAL (0~9) button to move to the channel directly. Press the DTV CH ( ) or RADIO CH ( channel and Radio channel. ) button to switch between TV Note : You can switch channel using the channel list or programme guide. 2. 2 Change the Subtitle Language If the current programme provides Subtitle information, you can select the language for the Subtitle. 1. Press the SUBTITLE ( ) button to display the subtitle language list. Select your desired subtitle language using the / button, and press the OK ( ) button. Then the subtitle will be displayed in the selected language at the bottom of the screen. Select OFF from the subtitle language list if you do not wish to display subtitles in the screen. Detailed Programme Information You can see detailed information about the current programme. Press the INFO ( ) button. Note : _ Press the INFO ( ) button again to hide the information box. _ If the detailed programme information is more than one page, use / button to move to the previous or next page. 2. 5 MHEG Application The MHP application makes possible not only access to the Internet and exchange e-mail through TV but also put the receiver directly into conventional television state. 1. Press the TXT ( ) button or the key which the data programme help you to press. Select your desired application using the button, and press the OK ( ) or button. Note : Please refer to the detailed information of each MHEG application if you operate the MHEG application. 31. DTV - Channel List 3. 1 Displaying and Switching Channel List You can display channel list using LIST ( on the channel list. 1. Press the LIST ( ) button while ) button and switch to other channels watching a channel to display the channel list. Select your desired channel using the / button and press the OK ( button to change the channel. Enter the channel number directly using NUMERICAL (0~9) button to move cursor on to your desired channel. And then press the OK ( ) button to change to the selected channel. [. . . ] + Check the setting of AV OUTPUT terminal. + Check the COLOUR and CONTRAST settings. + Make sure the BRIGHTNESS setting is not set too low. + Make sure the LCD-TV remote sensor is not facing a strong light source. [. . . ]