User manual HUMMINBIRD HDR 600

[. . . ] Thank you for choosing Humminbird, America's #1 name in depthsounders. Humminbird has built its reputation by designing and manufacturing top-quality, thoroughly reliable marine equipment. Your Humminbird is designed for trouble-free use in even the harshest marine environment. In the unlikely event that your Humminbird does require repairs, we offer an exclusive Service Guarantee ­ free of charge during the first year after purchase, and available at a reasonable rate after the one ­year period. [. . . ] Further adjustments may be necessary to tweak the installation after high speed testing. The metal bracket allows height and tilt adjustment, the pivot screws allow angular adjustment. Adjust the angle of the transducer body first, so it is parallel with the hull of the boat, and fully tighten the two pivot screws using the supplied Allen wrench. Access to the pivot screws is provided by the lower holes in the side of the mounting bracket. Note: On some hulls, it may be necessary to angle the transducer so that the back end is ¼" lower than the front. Next, adjust the height of the assembly so the face of the transducer is 1/8" to ¼" beneath the bottom of the transom, and fully tighten the three mounting screws. In order to gain access to the mounting screws, the transducer assembly must be pivoted up in the bracket as shown. Be careful not to alter the running angle as some force is necessary to pivot the assembly. If access to the top mounting hole is not possible due to the selected height of the transducer, fully tighten the two lower screws, then simply remove the headed pivot pin and the transducer assembly, and tighten the top screw, then reassemble. Finally, ensure that all mounting screws are fully tightened. Routing the Cable The transducer cable has a low profile connector that must be routed to the point where the HDR 600 unit will be mounted. Every boat is different and there may be several ways to route the cable. This is a standard hole saw readily available for rental or purchase. Or, any marine service shop can handle this task. Insert the HDR 600 from the front of the panel. Install the "U" bracket and wing nut from the rear of the panel ensuring that the face of the HDR 600 is rotated upright. If the panel into which you are mounting the unit is greater than ¼" thick, the "U" bracket may appear too long. You may modify the "U" bracket by using pliers to break the legs of the "U" bracket at the score lines. Shorten the bracket gradually to avoid making it too short. Tighten the wing nut to secure the installation. Once the unit is secured to the dash, the buzzer can be secured either to the metal bracket or a nearby wire bundle using the cable ties included. Plug the transducer cable to the transducer connector. Notice the connector is keyed to prevent reverse installation, so be careful not to force the plug into the connector. Next, proceed with making the electrical connections. If your boat has an electrical system, there is probably fuse panel in the console area, which can be used to attach the HDR 600 power cable. If a fuse terminal is available, use crimp-on type electrical connectors (not included), which match the terminal on the fuse panel, and attach the black wire to ground, and the red wire to 12 VDC power. [. . . ] After your selection is made, the unit will return to normal operation after 5 seconds. The "KO" icon should now be visible as shown in figure 13. Figures 11, 12, and 13 depict a scenario where the KEEL OFFSET has been set to ­2 feet. Figure 13 shows the return to normal operation with the updated depth readout. MAINTENANCE AND WARRANTY TROUBLESHOOTING Do not attempt to repair the HDR 600 yourself. [. . . ]