User manual HUMMINBIRD LCR 400 ID

[. . . ] TABLE OF CONTENTS INSTALLATION PREPARATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Parts Supplied. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The simulator displays a typical underwater scene, and lets you practice with the controls. The unit must be turned off before you start the simulator. To activate it, press down and hold the POWER button until a chirping sound begins. Release the button, and the built-in simulator begins displaying a typical LCR 400ID reading. You can use the simulator to learn the functions explained in the following pages, just as if you were getting actual on-the-water readings (but note that "Sensitivity" is disabled). To turn off the simulator, turn off the unit by pressing the POWER button again. Of course, the best way to learn the LCR 400ID is with actual use, especially in familiar waters. If you know what's below and see it on-screen, you'll quickly become an LCR 400ID expert. USING THE LCR400ID OPERATING THE LCR400ID FRONT PANEL BUTTONS The LCR 400ID offers several functions that you can adjust with the front panel buttons. (Note that to select something with a button, you must press it fully so that you hear a "chirp" sound). You can get acquainted with these features by actual operation, or when using the simulator. POWER: Press this once to turn the LCR 400ID on. Pressing it again turns the LCR 400ID off. (Any adjustments you make with the other front panel buttons are retained, as long as the 12-volt DC power supply remains connected). When the unit is off, keeping POWER pressed for about 2 seconds starts the built-in simulator. STOP: Press this to "freeze" the display so you can study it. Press it again to restart the display movement. SELECT: This button is used to access the following functions for further adjustments: · · · · · · · · Sensitivity/Units Bottom Alarm Fish Alarm Zoom Bottom Lock Display Speed Depth Range Fish ID To adjust any of these, press SELECT until the function you want appears. Each function's display tells you how to use the arrow buttons and ON/OFF for adjustment; when first learning, you should also refer to the following instructions. After you adjust any function, the display returns to its full-screen reading. NOTE: The last function you select remains "active" ­ that is, you can adjust it without having to press SELECT again. You can use this to simplify operations. For example, if the bottom alarm is the last function used, you can readjust the alarm by pressing one of the arrow buttons. [. . . ] Accessories not manufactured under the Humminbird trade name are not covered by our warranty. The customer is responsible for shipping charges to Humminbird. Humminbird will provide ground UPS or Parcel Post shipping back to the customer free of charge. This warranty applies to the original purchaser only. [. . . ]