User manual HUMMINBIRD TS W

[. . . ] The module is intended for installation on the transom, and will work well on almost any boat. Note: If the Temperature/Speed accessory will not work for your application, you may exchange it, NEW and UNASSEMBLED, with mounting hardware included, for an accessory that is appropriate for your application - often at very little or no charge depending on the accessory. Call the Humminbird Customer Resource Center (334-687-0503) for details and pricing, or visit www. humminbird. com, Product Support for more information. [. . . ] Wood screw Figure 1 and washer INSTALLATION pn530523-1r91219F You may route the cable over the top of the transom, or drill a /" (16 mm) diameter hole in the transom directly above the module and above the waterline to route cable through. Use the cable clamps provided to secure the cable to the transom of the boat. If a throughhole is used, an escutcheon plate is included to dress the hole. Note: On fiberglass hulls, it is best to start with a smaller bit and use progressively larger drill bits to reduce the chance of chipping or flaking the outer coating. All mounting screws require a /" pilot hole drilled approximately /" deep. Additionally, seal any hole drilled in the transom of the boat with marine-grade silicone sealant (not included). Route the cable to your Control Head, and install the connector in the appropriate slot. Use the connector designated for accessories (labeled A) on the Control Head. Note: Refer to your Control Head installation guide for more information about the quick disconnect connector included with your Control Head. If the connections are correct, the Control Head will begin displaying water temperature and boat speed information immediately. If the speed sensor ROUTING CABLE THE fails to read properly at high speeds, adjust the height of the module on the transom. Rotating Retaining Axial Clip to Remove Paddlewheel. Figure 2 You should periodically CLEANING remove the paddlewheel from the housing and clean it to remove growth resulting from the marine environment, as a clean paddlewheel results in more accurate readings. Note: This procedure should only be performed when the boat is not running, and is normally performed when the boat is out of the water. Clean the paddlewheel by disengaging the axial clip from the housing wedge and rotating it forward. Once you have rotated the axial clip, remove it from the housing by sliding it away from the holes in the housing. The paddlewheel is now removed; clean it with a mild solution of biodegradable soap or hot water. [. . . ] and Canada, hours are Monday - Friday, 8:00 a. m. Humminbird 108 Maple Lane Eufaula, AL 36027 WARNING: Disassembly and repair of this electronic unit should only be performed by authorized service personnel. Any modification of the serial number or attempt to repair the original equipment or accessories by unauthorized individuals will void the warranty. [. . . ]