User manual HUNTER 30260

[. . . ] This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat or override this safety feature. [. . . ] Circle the month and write the year of installation for the pre-filter and HEPA filter. Be sure that the bottom grille tabs are in position first, and then push the top of the grille forward until it is closed. The unit is now ready for normal operation. NOTE: This unit will not operate unless the door is placed in the correct position. Plug the unit into a 120V electrical outlet. AIR PURIFIER PARTS TM HEPA FILTER PREFILTER RECESS FOR FINGERS TO PULL OPEN FRONT GRILLE FRONT GRILLE QuietFloTM 210 FIGURE 1A TM HEPA FILTER PREFILTER FRONT GRILLE RECESS FOR FINGERS TO PULL OPEN FRONT GRILLE QuietFloTM 260 FIGURE 1B FORM 41450-01 6/2000 3 ©2000 HUNTER FAN CO. "HOOK" TAPE "HOOK" TAPE GRILLE VENTS GRILLE VENTS Inside View of Front Grille Inside View of Front Grille "HOOK" TAPE QuietFloTM 210 "HOOK" TAPE QuietFloTM 260 FIGURE 2A FIGURE 2B Operating Your Air Purifier Models 30210 and 30260 On/Speed Control: Rotate this knob to turn the unit `on'. The knob rotates through "Off", "Low", "Medium" and "High". Keep rotating the knob to change speeds until you reach the speed you desire. When the power is "on", the red light will be illuminated. Cleaning And Filter Replacement (These Air Purifiers use Replacement HEPA Filter #30940 and Activated Carbon Pre-Filter #30903) 1. Clean the outside of the unit with a soft, damp cloth. The front grille can be removed and cleaned in soapy water. Remove the pre-filter before cleaning the front grille. At least every 90 days, open the front grille, remove the carbon pre-filter, and replace it. This is necessary to maintain proper odor-removing and overall filtration performance. If necessary, it can be changed more often. Mark the new filter installation sticker included with the new carbon pre-filter. Be sure to remove any plastic wrapping that may be on the new filter before you place it into the Air Purifier. While replacing the pre-filter, you should view the condition of the QuietFloTM HEPA Filter. Compare the filter to the color coded chart that is on the inside of the housing. If the filter matches the dark color on the chart, you should remove the filter and replace it with a new filter. Mark the new filter installation sticker included with the new QuietFloTM HEPA Filter. Depending on use and environment, the HEPA Filter should last one year. If you notice a decrease in air output or an increase in noise, the HEPA Filter may be clogged. [. . . ] For the name of our nearest authorized Hunter Fan Company Service Centre, write to the Hunter Fan Company at the preceding address. You will be responsible for insurance and freight or other transportation to our factory service center. We will return the Air Purifier freight prepaid. The Air Purifier should be properly packaged to avoid damage in transit since we will not be responsible for any such damage. [. . . ]