User manual HUSKY LINERS 56101

[. . . ] JEEP GRAND CHEROKEE FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install paint protection film before mud guard (see other side). Please read instructions thoroughly before installation. [. . . ] Using mud guard as a template, mark, drill 1/8 hole and install #10 screw and washer at location A (Figure 1). Using mud guard as a template, mark, drill 1/8 hole and install #10 screw and washer at location A, thru mud guard, fender cladding and into a u-clip on the backside of liner. The u-clip is used as a nut, DO NOT clip over liner or sheet metal (Figure 3). PAINTING INSTRUCTIONS 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. Sand painting surface with 320 grit sand paper. Apply a coating of flexible primer-adhesion promoter. Apply a flexible paint as directed by the paint manufacturer 5610 Jeep Grand Cher#1324BB. doc Rev: 0 PART NO. PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS 5610 NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent. [. . . ] Using a sponge, squeegee any air bubbles and wrinkles from film. Allow film to dry before installing mud guard. 5610 Jeep Grand Cher#1324BB. doc Rev: 0 [. . . ]