User manual HUSKY LINERS 56601

[. . . ] FORD F-150 WITHOUT FACTORY FENDER FLARES FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required · 1/8" drill bit / Drill · Short #2 Phillips screwdriver · Center punch Package Contents Driver & passenger side front mud guard #10 screw (qty. [. . . ] Install #10 screw and washer at location A. Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip. DO NOT CLIP U-CLIP OVER FENDER LINER ­ THE U-CLIP ACTS AS A NUT AND IS PLACED ON THE BACKSIDE OF LINER. PAINTING INSTRUCTIONS 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. Sand painting surface with 320 grit sand paper. Apply a coating of flexible primer-adhesion promoter. Apply a flexible paint as directed by the paint manufacturer. 5660 Front Instructio#1170F. doc Rev: 0 PART NO. PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS 5660 NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent. Mark correct position of film by placing mud guard against fender. [. . . ] Using a sponge, squeegee any air bubbles and wrinkles from film. Allow film to dry before installing mud guard. 5660 Front Instructio#1170F. doc Rev: 0 [. . . ]