User manual HUSQVARNA 125 C

[. . . ] Operator’s Manual 125C 125L Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English CONTENTS Contents CONTENTS Contents . 3 SAFETY INSTRUCTIONS Personal protective equipment . 5 Checking, maintaining and servicing the machine’s safety equipment . 12 Fitting the trimmer guard and trimmer head . [. . . ] Stop the machine immediately if anyone approaches. S Do not allow the trimmer head to constantly come into contact with the ground during normal cutting. Constant contact of this type can cause damage and wear to the trimmer head. 10 KNOW YOUR TRIMMER 1 2 3 125L 6 8 4 5 16 1 9 10 11 125C 7 15 13 14 12 4 1 17 18 KNOW YOUR TRIMMER 1. 19. Starter handle Fuel tank Choke control Air purge Air filter cover Handle adjustment Drive disc 2-stroke engine oil Operator’s manual (EPA) 19 11 ASSEMBLY Make sure unit is assembled correctly as shown in this manual. Fitting the loop handle S Position the handle on the shaft. Note that the handle must be mounted between the two arrows on the shaft. Fitting the trimmer guard and trimmer head (Model 125C) S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the wing nut (B). B A S Fit the screw, securing plate and wing nut as shown in the diagram. S Tighten the wing nut. C S Fit the dust cup (C) on the shaft. The nut must be completely covered by the dust cup. S Hold the dust cup with a wrench to prevent the shaft from rotating. S Screw the trimmer head (D) onto the shaft. Fitting the trimmer guard and trimmer head (Model 125L) S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (D). D B C D S To dismantle, follow the instructions in the reverse order. A A S Fit the drive disc (B) on the output shaft. S Turn the shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. S Insert hex wrench (C) in the hole to lock the shaft. S Screw on the trimmer head (H) in the opposite direction to the direction of rotation. H S To dismantle, follow the instructions in the reverse order. 12 FUEL HANDLING Fuel CAUTION!The machine is equipped with a two-stroke engine and must always be run using a mixture of gasoline and twostroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. S Always start by flling half the amount of the gasoline to be used. [. . . ] Should an operational problem or failure occur, the product should not be used, but delivered as is to an authorized Husqvarna dealer for evaluation. Proof of purchase, as explained in Section 6, rests solely with the customer. SECTION 4: EXCEPTIONS AND LIMITATIONS It is the Owner’s and Dealer’s responsibility to make certain that the Warranty Registration Card is properly filled out and mailed to Husqvarna Forest & Garden Company. This card should be mailed within ten (10) days from the date of purchase in order to confirm the warranty and to facilitate post-sale service. Proof of purchase must be presented to the authorized Husqvarna dealer in order to obtain warranty service. This proof must include date purchased, model number, serial number, and complete name and address of the selling dealer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna dealer in a timely manner, no later than thirty (30) days from date of the operational problem or failure. [. . . ]