User manual HUSQVARNA 125R

[. . . ] EN FR ES SYMBOL EXPLANATION Symbols WARNING: Clearing saws, brushcutters and trimmers can be dangerous!Careless or incorrect use can result in serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Always wear: S A protective helmet where there is a risk of falling objects S Hearing protection S Approved eye protection Max. [. . . ] Contact your dealer when selecting an oil. S Never use two-stroke oil intended for water-cooled outboard engines, sometimes referred to as outboard oil. S Never use oil intended for four-stroke engines. Two- stroke oil, litre 2% (1:50) 0, 10 0, 20 0, 30 0, 40 3% (1:33) 0, 15 0, 30 0, 45 0, 60 WARNING: Take care when handling fuel. Bear in mind the risk of fire, explosion and inhaling fumes. The machine is equipped with a two-stroke engine and must always be run using a mixture of petrol and two-stroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. Petrol, litre 5 10 15 20 WARNING: Fuel and fuel fumes are highly inflammable and can cause serious injury when inhaled or allowed to come in contact with the skin. For this reason observe caution when handling fuel and make sure there is adequate ventilation. 13 FUEL HANDLING Mixing S Always mix the petrol and oil in a clean container intended for fuel. S Always start by flling half the amount of the petrol to be used. S Mix (shake) the fuel mixture thoroughly before filling the machine's fuel tank. Fuelling S Do not mix more than one month's supply of fuel at a time. S If the machine is not used for some time, the fuel tank should be emptied and cleaned. The muffler gets very hot during and after use. Be aware of the fire hazard, especially when working near flammable substances and/or vapors. WARNING: Taking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. Always shut off the engine before refueling. Always stop the engine and let it cool for a few minutes before refuelling. When refueling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refueling. Always move the machine away from the refueling area before starting. S Clean the area around the fuel cap. Contamination in the tank can cause operating problems. S Ensure that the fuel is well mixed by shaking the container before filling the tank. WARNING: Min. 3 m 14 STARTING AND STOPPING Check before starting Starting and stopping S Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. [. . . ] Adjust the gap to 0, 6 mm or replace the spark plug. Check that the spark plug is fitted with a suppressor. Clean the outside of the carburetor and the space around it. Check that the bevel gear is filled threequarters full with lubricant. [. . . ]