User manual HUSQVARNA 141

[. . . ] The user advice and spare parts mentioned in this document are given as an indication, and do not constitute an undertaking. No warrantee will be granted in the event of errors or omissions, or for damage occur-ring during delivery, or caused by the design or use of the machine. We are very concerned about the quality of our products and we reserve the right to make any technical modifications to improve them, without warning. Prevent accidents due to unsuitable use, by an untrained person, during maintenance, repairs, overhauls, handling or transport · improve the reliability and durability of the machine · Ensure correct use, regular maintenance, and fast fault finding in order to reduce repair costs and down time. [. . . ] DO carefully read and make sure that you have understood all instructions before using the saw. Keep all safety guards in place always wear approved ear, eye, head and respiratory protective equipment always keep a safe distance from the disc and other moving parts know how to stop the saw fast in case of emergency. Before starting, read the instructions carefully and get familiar with the machine. Verify the following: ELECTRICAL SAFETY: Must be connected to power source using a grounded 30mA residual differential current circuit-breaker. Should their be no such circuit breaker on the power supply network, please see our catalogue for different models available. For tools with an RDC system built into the electrical cord or plug: should the cord or plug become damaged, repairs may be performed only by the manufacturer, their authorized agent or a qualified repair shop in order to avoid any hazard due to improper repair. Motor power supply: reinforced HO7 RNF electrical cable with 5 x 2. If the motor does not rotate in the desired direction, inverse two phases by turning two power socket terminals. The work area must be orderly, well lit and hazard free (eg no moisture and no hazardous products nearby). Use only discs marked with a maximum operating speed greater than that of the disk shaft Should the machine wear out or break, it must be disposed of in compliance with legislation in force. Always check ambient health & safety conditions. For heat engine machines: Start motor according to manufacturer's instruction manual. Heat engine: switch off at machine control panel Turn switch (8) to "Y" position then to . Electric motor: press red emergency stop button (7) or turn contactor (9) to position "O". Gently move the cutting head forward using the wheel (6) [FIG. Once the cut has been made, use wheel (6). To gently back the head up to its maximum rear position. Store diamond tool where it will not get warped or otherwise damaged. Store products in a safe and secure place, out of the reach of children. See motor manual for oil change and oil filter replacement intervals. Use class API MS, SD, SE or higher for gasoline (petrol) engines. After a certain amount of use, it may be necessary to restretch the belt. [. . . ] SCOPE The guarantee is limited to free replacement of parts having manufacturing defects recognized by Dimas (except for wearing parts and consumables) if repairs are performed in a workshop operated or approved by Dimas. The manufacturer will not be held accountable for any direct or indirect material damages or consequential losses caused by persons or things following failure or stoppage of the machine. CONDITIONS OF GUARANTEE To be entitled to the guarantee, the user must return the certificate of guarantee duly completed to Dimas within eight days of purchase. Should a problem occur during the guarantee period, our customer service department will tell you of the best way to solve it and, if necessary, inform you of the closest approved service center. [. . . ]