User manual HUSQVARNA 226 HD60 S

[. . . ] WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Operator’s manual WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. APPLICABLE SERIAL NUMBERS: 81200101 and up 226HD60S 226HD75S English 115 14 06-95 English Contents Symbols on the machine ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 4 Introduction ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 4 DEAR CUSTOMER!••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 4 SAFETY FIRST •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 WARNINGS IN THE MANUAL • ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 SYMBOLS•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 Safety ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 Warning labels on the machine ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 What is what?According to these indications, please be careful not to take a mistake. [. . . ] If Husqvarna oil is not available, use an antioxidant added quality oil expressly labeled for aircooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE) • Do not use BIA or TCW (2-stroke water-cooling type) mixed oil. RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1 50:1 MIXING CHART GASOLINE gal. 2-CYCLE OIL fl. oz GASOLINE liter 2-CYCLE OIL ml 1 2. 6 1 20 2 5. 2 2 40 3 7. 8 3 60 4 10. 4 4 80 5 13 5 100 FUELING THE UNIT 1. Untwist and remove the fuel cap. Keep the cap and inlet of the tank clean. 2. Put fuel into the fuel tank to 80% of the full capacity. 3. Fasten the fuel cap securely and wipe up any fuel spillage around the unit. WARNING • Exhaust emission are controlled by the fundamental 1. Select bare ground for fueling. 2. Move at least 10feet (3meters) away from the fueling point before starting the engine. 3. Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container. FOR YOUR ENGINE LIFE, AVOID; 1. FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly. 2. GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication. 3. OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking. 4. Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly. 5. In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel. 6. In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site. NOTE • • • • • engine parameters and components(eq. , carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion. These engines are certified to operate on unleaded gasoline. Make sure to use gasoline with a minimum octane number of 89 RON (USA/Canada: 87AL) If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine temperature may rise and an engine problem such as piston seizing may consequently occur. Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment. Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine. As for details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, etc. [. . . ] Throughout the emissions warranty period of two years, Husqvarna Forest & Garden must maintain a supply of warranted parts sufficient to meet the expected demand for such parts. WARRANTY PERIOD Any warranted part that is scheduled for replacement as required in the maintenance schedule, is warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part will be repaired or replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replacement point for the part. [. . . ]