User manual HUSQVARNA 226 HS755 S

[. . . ] WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Operator’s manual WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. APPLICABLE SERIAL NUMBERS: 70100101 and up 226HS75S 226HS99S English 115 08 64-95 English Contents Symbols on the machine •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 4 Introduction •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 4 DEAR CUSTOMER!•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 4 Safety •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 SAFETY FIRST ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 WARNINGS IN THE MANUAL •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 6 Warning labels on the machine •••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 SYMBOLS ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• 5 What is what?According to these indications, please be careful not to take a mistake. [. . . ] Measure out the quantities of gasoline and oil to be mixed. Put some of the gasoline into a clean, approved fuel container. Pour in all of the oil and agitate well. Pour In the rest of gasoline and agitate again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormal lean mixture. Put a clear indication on the outside of the container to avoid mixing up with other containers. Indicate the contents on outside of container for easy identification. • The Husqvarna engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If Husqvarna oil is not available, use an antioxidant added quality oil expressly labeled for aircooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE) • Do not use BIA or TCW (2-stroke water-cooling type) mixed oil. RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1 50:1 MIXING CHART GASOLINE gal. 2-CYCLE OIL fl. oz GASOLINE liter 2-CYCLE OIL ml 1 2. 6 1 20 2 5. 2 2 40 3 7. 8 3 60 4 10. 4 4 80 5 13 5 100 FUELING THE UNIT 1. Keep the cap and inlet of the tank clean. Put fuel into the fuel tank to 80% of the full capacity. Fasten the fuel cap securely and wipe up any fuel spillage around the unit. WARNING 1. Move at least 10feet (3meters) away from the fueling point before starting the engine. Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container. FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly. GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication. OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking. Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly. In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. [. . . ] Throughout the emissions warranty period of two years, Husqvarna Forest & Garden must maintain a supply of warranted parts sufficient to meet the expected demand for such parts. WARRANTY PERIOD Any warranted part that is scheduled for replacement as required in the maintenance schedule, is warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part will be repaired or replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replacement point for the part. [. . . ]