User manual HUSQVARNA 226 R

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. A clearing saw, brushcutter or trimmer can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of this operator's manual. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. [. . . ] It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. Fuel and fuel fumes are highly inflammable and can cause serious injury when inhaled or allowed to come in contact with the skin. For this reason observe caution when handling fuel and make sure there is adequate ventilation. Always mix the petrol and oil in a clean container intended for fuel. always start by filling half the amount of the petrol to be used. Taking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. Always shut off the engine before refuelling. Always stop the engine and let it cool for a few minutes before refuelling. When refuelling, open the fuel cap slowly so that any excess pressure is released gently. tighten the fuel cap carefully after refuelling. Always move the machine away from the refuelling area before starting. Do not mix more than one month's supply of fuel at a time. If the machine is not used for some time the fuel tank should be emptied and cleaned. Always use a fuel container with an anti-spill valve. contamination in the tank can cause operating problems. Ensure that the fuel is well mixed by shaking the container before filling the tank. Trimmer guard if they have been exposed to impact or are cracked. Never use the machine without a guard nor with a defective guard. All covers must be correctly fitted and undamaged before you start the machine. Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. [. . . ] The filter must therefore be replaced with a new one at regular intervals. These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties. If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0, 6-0, 7 mm. [. . . ]