User manual HUSQVARNA 235 E TRIO BRAKE

[. . . ] Noise emission to the environment according to the European Community's Directive. The machine's emission is specified in chapter Technical data and on label. Both of the operators hands must be used to operate the chain saw. Always wear approved protective gloves. Regular cleaning is required. Never operate a chain saw holding it with one hand only. Visual check. Never let the guide bar tip come in contact with any object. Protective goggles or a visor must be worn. Use appropriate protections for foot-leg and hand-arm. Refuelling. Filling with oil and adjusting oil flow. Never let the guide bar tip come in contact with any object. [. . . ] · 1 2 Never start the machine: If you have spilt fuel or chain oil on the machine. Wipe off the spillage and allow remaining fuel to evaporate. If you have spilt fuel on yourself or your clothes, change your clothes. Wash any part of your body that has come in contact with fuel. Check regularly for leaks from the fuel cap and fuel lines. 3 ! · Clean the area around the fuel cap. Clean the fuel and chain oil tanks regularly. The fuel filter must be replaced at least once a year. Contamination in the tanks causes malfunction. Make sure the fuel is well mixed by shaking the container before refuelling. The capacities of the chain oil tank and fuel tank are carefully matched. You should therefore always fill the chain oil tank and fuel tank at the same time. WARNING!Activate the brake by moving the front hand guard forwards. Grip the front handle with your left hand and push the chain saw to the ground. Grip the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) and then pull firmly and rapidly. Never twist the starter cord around your hand. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. Push down the choke control as soon as the engine fires which can be heard through a "puff" sound. Keep on pulling the cord powerfully until the engine starts. When English ­ 19 STARTING AND STOPPING the engine starts, quickly apply full throttle; the throttle start lock will automatically disengage. As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by quickly disengaging the throttle lock. This prevents unnecessary wear to the clutch, clutch drum and brake band. [. . . ] If the bar has a sprocket tip, this should be lubricated. Check that the bar and chain are getting sufficient oil. Check the saw chain with regard to visible cracks in the rivets and links, whether the saw chain is stiff or whether the rivets and links are abnormally worn. Sharpen the chain and check its tension and condition. [. . . ]