User manual HUSQVARNA 532440661R1

[. . . ] 07002 LGT25K54 Owner's Manual Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. 532 44 06-61 Rev. 1 SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. WARNING: In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. [. . . ] When doing a second cut, mow across (perpendicular) to the first cut path. Change your cutting pattern from week to week. Mow north to south one week then change to east to west the next week. This will help prevent matting and graining of the lawn. 17 MAINTENANCE MAINTENANCE SCHEDULE Check Brake Operation BEFORE EACH USE EVERY 8 HOURS EVERY 25 HOURS EVERY 50 HOURS EVERY 100 HOURS EVERY SEASON BEFORE STORAGE T R A C T 0 R Check Tire Pressure Check Operator Presence & ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Clean Debris Off Steering Plate Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1, 2 1, 2 2 2 5 4 3 E N G I N E Change Engine Oil (without oil filter) Clean Air Filter Clean Air Screen Inspect Muffler/Spark Arrester Replace Oil Filter (If equipped) Clean Engine Cooling Fins Replace Spark Plug Replace Air Filter Paper Cartridge 1, 2 2 2 Replace Fuel Filter 1 - Change more often when operating under a heavy load or in high ambient temperatures. 2 - Service more often when operating in dirty or dusty conditions. 3 - Replace blades more often when mowing in sandy soil. 4 - Not required if equipped with maintenance-free battery. 5 - See Cleaning in Maintenance Section. GENERAL RECOMMENDATIONS The warranty on this tractor does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain tractor as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tractor. At least once a season, check to see if you should make any of the adjustments described in the Service and Adjustments section of this manual. • At least once a year you should replace the spark plug, clean or replace air filter, and check blades and belts for wear. A new spark plug and clean air filter assure proper air-fuel mixture and help your engine run better and last longer. LUBRICATION CHART ➀ SPINDLE ZERK ➀ FRONT ➀ SPINDLE ZERK ➀ FRONT WHEEL BEARING ZERK WHEEL BEARING ZERK ➀ STEERING SECTOR GEAR TEETH ➁ ENGINE ➀ MANDREL ZERKS BEFORE EACH USE • • • • • Check engine oil level. Check operator presence and ROS systems for proper operation. Check for loose fasteners. 02501 ➀ ➁ General Purpose Grease Refer to Maintenance “ENGINE” Section 18 IMPORTANT: DO NOT OIL OR GREASE THE PIVOT POINTS WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS LUBRICANTS WILL ATTRACT DUST AND DIRT THAT WILL SHORTEN THE LIFE OF THE SELF-LUBRICATING BEARINGS. IF YOU FEEL THEY MUST BE LUBRICATED, USE ONLY A DRY, POWDERED GRAPHITE TYPE LUBRICANT SPARINGLY. MAINTENANCE TRACTOR Always observe safety rules when per form ing any maintenance. BRAKE OPERATION If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual). TIRES • Maintain proper air pressure in all tires (See the sides of tires for proper PSI). • Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber. • Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage. [. . . ] 960 48 00-12 MOWER DECK 46 46 47 6 185 39 34 192 49 21 122 114 52 7 46 43 196 97 49 33 52 241 31 1 33 242 30 102 98 32 33 32 106 31 105 104 103 101 104 106 103 105 46_mulch_plate_1_r1 102 116 117 120 49 113 194 12 21 21 59 18 18 190 18 18 18 15 18 13 21 58 21 16 19 27 21 60 21 29 50 25 26 24 189 21 14 190 187 184 187 8 11 18 mower_deck 54-tex_19 42 TRACTOR - MODEL NO. 1 6 7 8 11 -12 13 14 16 15 18 19 21 24 25 26 27 29 30 31 32 33 34 39 43 46 47 49 50 52 58 59 60 97 PART NO. 532 44 15-47 532 19 60-66 532 19 71-81 532 19 30-03 532 18 72-56 532 18 72-55 532 40 48-51 532 18 72-91 532 18 72-81 819 13 13-12 532 11 04-85 872 14 05-05 532 19 42-08 873 68 05-00 532 10 53-04 532 17 81-02 532 11 04-52 532 18 89-38 532 13 14-91 532 17 39-84 532 18 76-90 532 15 35-35 532 40 02-34 873 68 06-00 532 19 73-80 532 19 60-65 532 13 77-29 532 19 61-03 873 90 06-00 872 11 06-16 532 19 73-79 532 18 73-42 532 18 73-44 532 18 76-07 532 17 85-15 DESCRIPTION Deck Weldment Mower Cover Mandrel LH Cover Mandrel RH Bolt 7/16 Asm. Blade Blade Bagging Blade Mulching Rod Anti-Sway Shaft Asm. [. . . ]