User manual HUSQVARNA 576769101

[. . . ] BP5 U S OWNER/OPERATOR MANUAL BACKPACK SPRAYER BP5 WARNING This sprayer is not designed to be used with acids of any kind, corrosive products like caustic soda, gasoline, materials capable of generating heat, hot fluids, explosive or highly volatile products. USE OF THESE AND OTHERS EXPOSE USERS TO SERIOUS INJURY AND EVEN DEATH. WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. US-1 BP5 SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the sprayer concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. Note that there may be times when warning seals peel off or become soiled and impossible to read. If this happens, you should contact the dealer from which you purchased the product to order new seals and affix the new seal(s) in the required location(s). NOTES ON TYPES OF WARNINGS Instructions labeled as shown at left, concern critical steps or procedures which must be followed in order to prevent accidents which could lead to serious bodily injury or death. This mark is used to indicate instructions which must be followed without exception. Instructions labeled as shown at left concern steps or procedures which, if not followed correctly, could lead to mechanical failure, breakdown, or damage. Used to label supplementary instructions designed to provide hints or directions useful in the use of the product. Contents 1. [. . . ] After using sprayers and other equipment, CLEAN UP!Dispose of debris in trash receptacles. In order to maintain your product in proper working order, perform the main tenance and checking operations described in the manual at regular intervals. Examine the sprayer at intervals for loose fasteners and rusted or damaged parts. Use special care for chemical leakage. 3 Clean and rinse tank and spraying assembly after each use to prevent crystallizing, which would later cause clogging and chemical damage to the unit. All service except for those described in this manual should be performed by competent service personnel. When replacing any other part, or any lubricant, always be sure to use only Husqvarna products or products which have been certified by Husqvarna for use with the Husqvarna product. When it is almost through, place the bent portion of the pump lever through the hole on the flat portion of the handle. Once through, place on one washer and, then the locking pin. The round tube comes through the base of the unit and extends out 6. 4mm (1/4”), exposing the hole drilled through the tube. Place on the other washer and the other holding pin. The pump handle assembly is now complete. HIP SUPPORT Take the black plastic hip portion and side the two end sections into the two receiving notches on the base, the rounded side up. STRAPS Hook the plastic clip attached to the shoulder straps into the appropriate lateral opening on the hip support. SPRAY WAND AND NOZZLE Attach spray wand to spray gun and firmly tighten. To adjust nozzle, tighten (turn clockwise), cap for a fine atomized spray, or loosen (turn counter clockwise), for a coarser spray or solid stream. THE SPRAYER IS NOW READY TO USE. Hose clamps are not completely tight. Please tighten hose clamps prior to using. Hose clamps are left loose to extend life of gaskets and fittings. Fig. 2 Oil cap gasket before using and lubricate weekly so the gasket will seal properly and prevent chemical leaks. Oil check valve and keep breather hole clear of debris. [. . . ] Pressurize, and flush pumping system by depressing trigger for at least two minu tes; then drain all remaining water. Always store tank clean and empty in a dry, shaded location. 10. Disposal When disposing of your machine, or chemical, be sure to follow your local regulations. Failure to follow manufacturer’s recommendation of use and care of unit will void any expressed or implied warranty. [. . . ]