User manual HUSQVARNA 600 CRT

[. . . ] 600CRT Owner’s Manual SAFETY RULES Safe Operation Practices for Walk-Behind Powered Rotary Tillers TRAINING • Read the Owner’s Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly. Never allow children to operate the equipment. [. . . ] Select the oil’s SAE viscosity grade according to your expected temperature. SAE VISCOSITY GRADES SAE 30 10W-30 / 5W-30 -20° °F °C -30° 0° -20° -10° 30° 40° 4° 10° 60° 20° 80° 30° 100° 40° TO SERVICE PRE-CLEANER TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE FIG. 16 NOTE: Although multi-viscosity oils (5W-30, 10W-30, etc. ) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 40°F (4°C). Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 25 hours of operation or at least once a year if the tiller is not used for 25 hours in one year. Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil filler plug securely each time you check the oil level. 16 and 17) Determine temperature range expected before oil change. All oil must meet API service classification SF, SG or SH. • Be sure tiller is on level surface. • Oil will drain more freely when warm. • Use a funnel to prevent oil spill on tiller, and catch oil in a suitable container. For easier removal of plug use 7/16 12 Pt. socket with extension. ) • Tip tiller forward to drain oil. • After oil has drained completely, replace oil drain plug and tighten securely. Be careful not to allow dirt to enter the engine. See “CHECK ENGINE OIL LEVEL” in the Operation section of this manual. OIL DRAIN PLUG • Remove foam pre-cleaner from air cleaner cover. • Wash it in liquid detergent and water. • If very dirty or damaged, replace pre-cleaner. • Reinstall pre-cleaner into air cleaner cover. • Reinstall cover and secure screw. TO SERVICE CARTRIDGE • Carefully remove cartridge to prevent debris from entering carburetor. Clean base carefully to prevent debris from entering carburetor. [. . . ] (5) Additional damage to parts or components due to continued use occurring after any of the above. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. HUSQVARNA SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THESE PRODUCTS EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THESE PRODUCTS IS LIMITED IN DURATION TO THE WARRANTY PERIOD AS DEFINED IN THE LIMITED WARRANTY STATEMENT. [. . . ]