User manual HUSQVARNA 700 HD60 EL

[. . . ] Always wear: · · Approved hearing protection Approved eye protection Protective goggles or a visor must be worn. Always wear approved protective gloves. Wear sturdy, non-slip boots or shoes. Other symbols/decals on the machine refer to special certification requirements for certain markets. 2 ­ English CONTENTS Contents KEY TO SYMBOLS Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CONTENTS Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Note the following before starting: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. Fuel and fuel fumes are highly inflammable and can cause serious injury when inhaled or allowed to come in contact with the skin. For this reason observe caution when handling fuel and make sure there is adequate ventilation. · · 10 15 20 US gallon 1 2 1/2 5 ! 10 ­ English FUEL HANDLING Mixing · · Always mix the gasoline and oil in a clean container intended for fuel. Always start by filling half the amount of the gasoline to be used. Mix (shake) the fuel mixture thoroughly before filling the machine's fuel tank. Fueling · ! WARNING!Taking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. Always shut off the engine before refuelling. Always stop the engine and let it cool for a few minutes before refuelling. When refuelling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refuelling. The complete clutch cover and gear housing must be fitted before the machine is started, otherwise the clutch may come loose and cause personal injury. Always move the machine about 3 metres from the refuelling position before starting. Remember that the blades may start to move when the engine is started. Make sure the blades cannot come into contact with any object. Make sure that no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 metres. Cold engine Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. Stopping The engine is switched off by moving the stop switch to the stop position. 12 ­ English WORKING TECHNIQUES General working instructions IMPORTANT!This section takes up the basic safety precautions for working with a hedge trimmer. If you encounter a situation where you are uncertain how to proceed you should ask an expert. Contact your dealer or your service workshop. Avoid all usage which you consider to be beyond your capability. [. . . ] Check the clutch, clutch springs and the clutch drum for wear. Replace if necessary by an autorized service workshop. Check that the spark plug is fitted with a suppressor. Check and clean the spark arrestor screen on the muffler (only applies to mufflers fitted with a catalytic converter). [. . . ]