User manual HUSQVARNA 954000662

[. . . ] 1 & 2) • Install two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown. NOTE: Pre-assemble weld nut to latch hook by inserting weld nut from the top with hook pointing down. [. . . ] • Place front of mulcher plate over front of mower deck opening and slide into place, as shown. • Hook front latch into hole on front of mower deck. • Hook rear latch into hole on back of mower deck. CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching mulcher plate and allow it to rest on plate while in operation. SCREW LATCH HOOK WASHER LOCK WASHER WASHER WELD NUT MULCHER PLATE SCREW FIG. 1 DEFLECTOR SHIELD TO CONVERT TO BAGGING OR DISCHARGING Simply remove mulcher plate and store in a safe place. At this time the grass has dried and the newly cut area will not be exposed to the direct sun. • For best results, adjust the mower cutting height so that the mower cuts off only the top one-third of the grass blades (See Fig. For extremely heavy mulching, reduce your width of cut and mow slowly. FIG. 3 • Certain types of grass and grass conditions may require that an area be mulched a second time to completely hide the clippings. When doing a second cut, mow across or perpendicular to the first cut path. • Change your cutting pattern from week to week. [. . . ] • Change your cutting pattern from week to week. Mow north to south one week then change to east to west the next week. [. . . ]