User manual HUSQVARNA 95417022100

[. . . ] Be sure the area is clear of other people before mowing. Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing. Be aware of the mower discharge direction and do not point it at anyone. [. . . ] Water in engine can result in a shortened engine life. CLEAN AIR SCREEN Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers. See engine manual. ENGINE COOLING FINS Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating. See engine manual. MUFFLER Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage. 14 SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • • • • • • Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key “OFF” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TO REMOVE MOWER (See Fig. 18) Mower will be easier to remove from the right side of tractor. • Park tractor on a level surface and engage parking brake. 19 MOWER STABILIZER LINK REAR LIFT LINKS FRONT LIFT LINK FIG. 18 15 SERVICE AND ADJUSTMENTS TO LEVEL MOWER HOUSING (See Figs. 20-23) Adjust the mower while tractor is parked on level ground or driveway. If tires are over or under inflated, you will not properly adjust your mower. NOTE: One rotation of trunnion nut is equivalent to approximately 1/8 inch of height change. Be sure upper and lower nuts are tightened against trunnion after adjustment has been completed. • Place attachment height adjustment knob in position “3” (See Fig. • Lower attachment lift lever to height adjustment knob. 21 and 22) • Measure distance from ground to lower flange of mower deck on both sides of mower (dim. “B” & “C” ). “B” & “C” should be the same. [. . . ] This proof must include date purchased, model number, serial number, and complete name and address of the selling dealer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna dealer in a timely manner, no later than thirty (30) days from date of the operational problem or failure. The product must be delivered at the owner’s expense. Pick-up and delivery charges are not covered by this warranty. [. . . ]