User manual HUSQVARNA 954567024

[. . . ] • Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blade. • Be sure the area is clear of other people before mowing. • Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing. [. . . ] An unbalanced blade will cause excessive vibration and eventual damage to mower and engine. • The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower. • To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with balancer). NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not. • Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced. CENTER HOLE OPERATOR PRESENCE SYSTEM Be sure operator presence and interlock systems are working properly. If your tractor does not function as described, repair the problem immediately. 18 & 19) Determine temperature range expected before oil change. All oil must meet API service classification SF, SG or SH. • Be sure tractor is on level surface. • Oil will drain more freely when warm. • Catch oil in a suitable container. Be careful not to allow dirt to enter the engine when changing oil. • Remove cap from bottom fitting of drain valve and install the drain tube onto the fitting. • Unlock drain valve by pushing inward and turning counterclockwise. • To open, pull out on the drain valve. • After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown. • Remove the drain tube and replace the cap onto to the bottom fitting of the drain valve. [. . . ] Drive Bar Pnt Adjusting Wheel Gauge Pin Head Rivet Washer 13/32 x 1 x 16 Ga. Bolt, Fin, Hex 3/8-16 UNC x 1 Bracket, Asm Noseroller, LH Nut, Lock, Hex w/Ins 3/8-16UNC Washer 17/32 x 7/8 x 16 Ga. Roller, Nose 38 & 42 Bracket, asm Noseroller RH Cover, Mulching Screw Washer, Lock #10 Washer Latch Asm. Bagger Nut, Weld Bolt, Shoulder Gauge Wheel Nut, Centerlock 3/8-16 UNC Washer 3/8 x 7/8 x 14 Ga. [. . . ]