User manual HUSQVARNA 96041031200

[. . . ] € Never allow children or people unfamiliar with the instructions to use the lawnmower. Local regulations may restrict the age of the operator. € Never mow while people, especially children, or pets are nearby. € Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] Repeat this driving procedure three times. Your tractor is now ready for normal operation. PURGE TRANSMISSION To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have developed during shipping of your tractor. iMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT , IT SHOULD BE PURGED AFTER REIN STALLATION BEFORE OPERATING THE TRACTOR. € Park tractor on level surface so it will not roll in any direction. Parking brake must be disengaged for the following procedure. The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/ disconnection lever in position “connection”. Driving Lower the cutting unit by moving the lever forwards. Connect the cutting unit and move the motion control lever to the required position. Choose a driving speed which suits the terrain and required cutting results. For larger lawns the drive direction should be changed after 2-3 turns so that the cut grass is thrown towards the area that has already been cut as shown in the illustration. Use the left side of the machine to cut close to trees, bushes and paths, etc. The blade cuts about 15 mm inside the edge of the cover. 41 5 Switching off the engine Move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. € When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine. € The attachment clutch should never operate unless the operator is in the seat. 02828 CHECK REVERSE OPERATION SYSTEM (ROS): • When the engine is running with the ignition switch in the Engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine. € When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine. 02 54 5 Blades For best results mower blades must be kept sharp. Sharpening can be carried out with a file or grinding disc. [. . . ] € While sitting in the operator’s position on the tractor, re-start the " position. Engine and place the throttle lever in the Fast " IMPORTANT: Recheck the area making certain the area is clear. € Move the tractor’s attachment clutch control to the “Engaged” position. Remain in the operator’s position with the cutting deck engaged until the deck is cleaned. [. . . ]